IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNARefer to the exhibit. R2 has two possible paths to the 192.168.10.4 network. What would make the alternate route meet the feasibility condition?ITExamAnswers asked 4 years ago • CCNP, CCNAWhich three options must match in order to establish an EtherChannel between two directly connected switches? (Choose three.)ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. Based on the command output shown, what is the status of the EtherChannel?IT Administrator asked 4 years ago • CCNA, CCNPMatch the steps with the actions that are involved when an internal host with IP address 192.168.10.10 attempts to send a packet to an external server at the IP address 209.165.200.254 across a router R1 that is running dynamic NAT. (Not all options are used.)IT Administrator asked 4 years ago • CCNA, CCNA CyberOps, CCNP, DevNetA network contains multiple VLANs spanning multiple switches. What happens when a device in VLAN 20 sends a broadcast Ethernet frame?ITExamAnswers asked 4 years ago • CCNA, DevNetWhat action takes place when a frame entering a switch has a multicast destination MAC address?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. Which sequence of commands should be used to configure router A for OSPF?ITExamAnswers asked 4 years ago • CCNAThe graphic shows the partial output of the show ip route command: Refer to the exhibit. What can be concluded about network 192.168.4.0 in the R2 routing table?ITExamAnswers asked 4 years ago • CCNA, CCNPWhat is the function of a QoS trust boundary?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. Which trunk link will not forward any traffic after the root bridge election process is complete?ITExamAnswers asked 4 years ago • CCNA, CCNPWhat is a requirement to configure a trunking EtherChannel between two switches?ITExamAnswers asked 4 years ago • CCNA, CCNPWhen JSON data format is being used, what characters are used to hold objects?IT Administrator asked 4 years ago • CCNA, CCNPA new switch is to be added to an existing network in a remote office. The network administrator does not want the technicians in the remote office to be able to add new VLANs to the switch, but the switch should receive VLAN updates from the VTP domain. Which two steps must be performed to configure VTP on the new switch to meet these conditions? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. A network administrator has connected two switches together using EtherChannel technology. If STP is running, what will be the end result?ITExamAnswers asked 4 years ago • CCNA, CCNPWhat is used to pre-populate the adjacency table on Cisco devices that use CEF to process packets?ITExamAnswers asked 4 years ago • CCNA, CCNP