IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAWhat are two improvements provided by automation for network management in an SDN environment? (Choose two)IT Administrator asked 3 years ago • CCNAWhat is a characteristic of private IPv4 addressing?IT Administrator asked 3 years ago • CCNARefer to the exhibit. Which command must be executed for Gi1.1 on SW1 to become a trunk port if Gi1/1 on SW2 is configured in desirable or trunk mode?IT Administrator asked 3 years ago • CCNAAn engineer observes high usage on the 2.4GHz channels and lower usage on the 5GHz channels. What must be configured to allow clients to preferentially use 5GHz access points?IT Administrator asked 3 years ago • CCNAWhich 802.11 management frame type is sent when a client roams between access points on the same SSID?IT Administrator asked 3 years ago • CCNAWhen a WLAN with WPA2 PSK is configured in the Wireless LAN Controller GUI which format is supported?IT Administrator asked 3 years ago • CCNAWhat uses HTTP messages to transfer data to applications residing on different hosts?IT Administrator asked 3 years ago • CCNAAn engineer must configure the IPv6 address 2001:0db8:0000:0000:0700:0003:400F:572B on the serial0/0 interface of the HQ router and wants to compress it for easier configuration. Which command must be issued on the router interface?IT Administrator asked 3 years ago • CCNAWhich WLC port connects to a switch to pass normal access-point traffic?IT Administrator asked 3 years ago • CCNAWhat is recommended for the wireless infrastructure design of an organization?IT Administrator asked 3 years ago • CCNAAn engineering team asks an implementer to configure syslog for warning conditions and error conditions. Which command does the implementer configure to achieve the desired result?IT Administrator asked 3 years ago • CCNAWhich two protocols are supported on service-port interfaces? (Choose two.)IT Administrator asked 3 years ago • CCNADrag and drop the 802.11 wireless standards from the left onto the matching statements on the rightIT Administrator asked 3 years ago • CCNARefer to the exhibit. How must router A be configured so that it only sends Cisco Discovery Protocol Information to router C?IT Administrator asked 3 years ago • CCNAWhich device controls the forwarding of authentication requests for users when connecting to the network using a lightweight access point?IT Administrator asked 3 years ago • CCNA