IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA
Refer to the exhibit. For the given topology, what are three results of the OSPF DR and BDR elections? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
Match each description to its corresponding LSA type. (Not all options are used.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Fill in the blank. A spanning-tree network that has all of the switched ports in either a blocking or forwarding state is considered a converged network.
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
An administrator issued the following commands on router R1. What conclusion can be drawn from this configuration?
IT Questions Bank 5IT Administrator asked 3 years ago • ,
The output of the show ip interface brief command indicates that Serial0 is up but the line protocol is down. What are two possible causes for the line protocol being in the down state? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
Which statement describes cable?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
Which three statements describe the building blocks that make up the IPsec protocol framework? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 3 years ago • ,
What two encryption algorithms are used in IPsec VPNs? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 3 years ago • ,
Refer to the exhibit. Inter-VLAN communication between VLAN 10, VLAN 20, and VLAN 30 is not successful. What is the problem?
IT Questions Bank 5IT Administrator asked 4 years ago • 
A network administrator is troubleshooting router RA in an EIGRP autonomous system. The administrator needs to obtain the IP addresses of the other routers with which router RA has established adjacencies. It is also important to obtain information of the queue counts on the neighbor routers. What command will do this?
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
Refer to the exhibit. A network technician has added router R0 to an existing network that contains router R1. R0 is configured with EIGRP and is connected to R1 via the Fa0/0 interface of each router. After completing an analysis of the network, the technician notices that the routes to the networks that are supported by routers R0 and R1 are not being exchanged. What is a possible cause for this failure?
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
Refer to the exhibit. R1 and R2 are connected to the same LAN segment and are configured to run OSPFv3. They are not forming a neighbor adjacency. What is the cause of the problem?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
What are three parameters that are used by NetFlow to classify traffic? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
What is an SNMP management agent?
IT Questions Bank 5IT Administrator asked 3 years ago • 
Which management protocol can be used securely with Cisco devices to retrieve or write to variables in a MIB?
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
« Previous1…1314151617…167Next »
Ask Question