IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAWhich statement describes the Cisco License Manager?IT Administrator asked 3 years ago • CCNARefer to the exhibit. Users on the R1 LAN and R2 LAN are unable to communicate. Based on the IPv6 addressing of the network displayed, what is the problem?ITExamAnswers asked 1 year ago • CCNAWhat is the value used to determine which port on a non-root bridge will become a root port in a STP network?ITExamAnswers asked 4 years ago • CCNP, CCNAWhich three STP states were replaced with the RSTP discarding state? (Choose three.)ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. A network administrator configured routers R1 and R2 as part of HSRP group 1. After the routers have been reloaded, a user on Host1 complained of lack of connectivity to the Internet The network administrator issued the show standby brief command on both routers to verify the HSRP operations. In addition, the administrator observed the ARP table on Host1. Which entry should be seen in the ARP table on Host1 in order to gain connectivity to the Internet?ITExamAnswers asked 4 years ago • CCNP, CCNARefer to the exhibit. A network administrator issues the show ipv6 eigrp neighbors command. Which conclusion can be drawn based on the output?ITExamAnswers asked 4 years ago • CCNAWhat command specifies a BGP neighbor that has an IP address of 5.5.5.5/24 and that is in AS 500?ITExamAnswers asked 4 years ago • CCNA, CCNPHow is a DHCPDISCOVER transmitted on a network to reach a DHCP server?IT Administrator asked 4 years ago • CCNA CyberOps, CCNA, Networking EssentialsRefer to the exhibit. Which two conclusions can be derived from the output? (Choose two.)ITExamAnswers asked 4 years ago • CCNP, CCNAWhen creating an IPv6 static route, when must a next-hop IPv6 address and an exit interface both be specified?ITExamAnswers asked 4 years ago • CCNA, CCNPWhich three requirements are necessary for two OSPFv2 routers to form an adjacency? (Choose three.)ITExamAnswers asked 4 years ago • CCNP, CCNARefer to the exhibit. All networks are active in the same EIGRP routing domain. When the auto-summary command is issued on R3, which two summary networks will be advertised to the neighbors? (Choose two.)ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. Why did R1 and R2 not establish an adjacency?ITExamAnswers asked 4 years ago • CCNA, CCNP, CCNPv8 ENARSIWhat is the reason for a network engineer to alter the default reference bandwidth parameter when configuring OSPF?ITExamAnswers asked 4 years ago • CCNA, CCNP, CCNPv8 ENARSIA network engineer is troubleshooting OSPFv2 routing issues on two connected routers. Which two requirements to form an adjacency need to be verified? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPv8 ENARSI