IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPWhat is a benefit of shared trees over source trees when comparing multicast distribution trees?ITExamAnswers asked 4 years ago • CCNPWhat message type would a receiver in a multicast environment send in order to receive a specific multicast feed?ITExamAnswers asked 4 years ago • CCNPWhich version of IGMP supports Source Specific Multicast (SSM)?ITExamAnswers asked 4 years ago • CCNPWhat is the default maximum response time for a general membership query message sent to the all-host group address 224.0.0.1 in an attached subnet?ITExamAnswers asked 4 years ago • CCNPWhich IP address does the BSR mechanism use to send all BSR messages?ITExamAnswers asked 4 years ago • CCNPWhat is the IP address for the Cisco-RP-discovery multicast group?ITExamAnswers asked 4 years ago • CCNPWhat is the hexadecimal representation of the first 24 bits of any multicast MAC address?ITExamAnswers asked 4 years ago • CCNPIGMP snooping examines traffic at which OSI layer(s)?ITExamAnswers asked 4 years ago • CCNPA company is deploying BGP multihoming to provide network connection redundancy for several branch sites. Which method can be used to avoid the branch transit routing situation?ITExamAnswers asked 4 years ago • CCNPEach line in the diagram represents a single connection from a user AS to an ISP AS. In which multihomed configuration is it necessary, if not required, to use BGP to exchange routing information?ITExamAnswers asked 4 years ago • CCNPRefer to the exhibit. A network administrator issues the show bgp ipv4 unicast command to check the routes in the BGP table. What does the symbol > indicate about a route?ITExamAnswers asked 4 years ago • CCNPRefer to the exhibit. Which two configurations will allow RTA to establish a neighbor relationship with RTB? (Choose two.)ITExamAnswers asked 4 years ago • CCNPWhat is a similarity between OSPFv2 and OSPFv3?ITExamAnswers asked 4 years ago • CCNPWhich two OSPFv3 LSA types are used to advertise IPv6 unicast address prefixes and prevent the need for SPF calculations every time an address prefix is added or changed on a routerITExamAnswers asked 4 years ago • CCNPWhat must be done as a prerequisite to starting the OSPFv3 process on a Cisco router?ITExamAnswers asked 4 years ago • CCNP