IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPWhich IP protocol number is reserved for OSPF by the IANA?ITExamAnswers asked 4 years ago • CCNPWhich OSPF neighbor state indicates that bidirectional communication has been established prior to LSDB synchronization?ITExamAnswers asked 4 years ago • CCNPWhich two Layer 2 multicast addresses are used for Layer 2 frames carrying OSPF messages? (Choose two.)ITExamAnswers asked 4 years ago • CCNPWhich statement is true about OSPF DR and BDR elections?ITExamAnswers asked 4 years ago • CCNPWhat is a characteristic of manual route summarization?ITExamAnswers asked 4 years ago • CCNPWhich two factors does an EIGRP router use to determine that a route to a remote network meets the feasible condition and is therefore loop-free? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNPWhich algorithm does the EIGRP routing protocol use?ITExamAnswers asked 4 years ago • CCNPRefer to the exhibit. What does the value 2816 represent in the output display?ITExamAnswers asked 4 years ago • CCNPWhen are EIGRP update packets sent?ITExamAnswers asked 4 years ago • CCNPWhere should EIGRP summarization be applied?ITExamAnswers asked 4 years ago • CCNPWhich multicast address does an EIGRP-enabled router use to send query packets?ITExamAnswers asked 4 years ago • CCNPWhich table is used by EIGRP to store all routes that are learned from EIGRP neighbors?ITExamAnswers asked 4 years ago • CCNPWhich static path would be the primary default path out of the network?ITExamAnswers asked 4 years ago • CCNPConsider the following command: ip route 192.168.10.0 255.255.255.0 10.10.10.2 5 What does the 5 at the end of the command signify?ITExamAnswers asked 4 years ago • CCNPA network administrator is configuring an EtherChannel trunk link to add additional allowed VLANs to pass the link. Which statement describes the process of this change?ITExamAnswers asked 4 years ago • CCNP