IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNP
What is the instance ID range reserved for the IPv4 unicast address family in OSPFv3?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
How are OSPFv3 interarea routes identified in the routing table?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. What address will R2 use as the destination address for sending OSPFv3 link-state request packets to R1?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What type of OSPF LSA is originated by ASBR routers to advertise external routes?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which three LSA types build the SPF tree for intra-area and interarea routes? (Choose three).
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which two networks are part of the summary route 192.168.32.0/22? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which method can be used to prevent type 3 LSAs on the backbone from being regenerated into a nonbackbone area?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
When does an OSPF router become an ABR?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
What is the default maximum number of equal-cost paths supported by OSPF?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which statement describes the creation of LSAs by ABRs in the discontinuous network situation?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. What is indicated by the O IA in the router output?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Where can interarea route summarization be performed in an OSPF network?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
What are two effects of using multiple OSPF areas? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What is the OSPF link cost of a Gigabit Ethernet interface if the reference bandwidth is configured as 10000 Mbps?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. An administrator has entered the commands shown on R1. However, the default route is not propagating to other OSPF routers. What configuration would likely correct this problem?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
« Previous1…127128129130131…133Next »
Ask Question