IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPIn which link aggregation mode does an interface initiate EtherChannel negotiation by sending LACP packets?ITExamAnswers asked 4 years ago • CCNPWhich three parameters must match, on the ports of two switches, for a PAgP Etherchannel to be created? (Choose three.)ITExamAnswers asked 4 years ago • CCNPWhen EtherChannel is configured, which mode will force an interface into a port channel without exchanging aggregation protocol packets?ITExamAnswers asked 4 years ago • CCNPWhich technology is an open protocol standard that allows switches to automatically bundle physical ports into a single logical link?ITExamAnswers asked 4 years ago • CCNPRefer to the exhibit. Which switching technology would allow data to be transmitted over each access layer switch link and prevent the port from being blocked by spanning-tree because of the redundant link?ITExamAnswers asked 4 years ago • CCNPA network administrator is planning to add a new switch to the network. What should the network administrator do to ensure the new switch exchanges VTP information with the other switches in the VTP domain?ITExamAnswers asked 4 years ago • CCNPWhat is the effect of entering the switchport mode trunk and switchport nonegotiate interface configuration commands on a Cisco Catalyst 2960 switch that is connected to a switch that does not support DTP?ITExamAnswers asked 4 years ago • CCNPRefer to the exhibit. An administrator tried to implement an EtherChannel between two switches by grouping the six physical ports as shown. However, the administrator was not successful. What is the reason for that?ITExamAnswers asked 4 years ago • CCNPWhat protocol or technology manages trunk negotiations between switches?IT Administrator asked 4 years ago • CCNPWhat is the default MST region name on Cisco switches?ITExamAnswers asked 4 years ago • CCNPWhat is a solution to mitigate the MST misconfiguration that contains improper VLAN assignment to the IST?ITExamAnswers asked 4 years ago • CCNPWhich two scenarios are examples of MST region boundaries? (Choose two.)ITExamAnswers asked 4 years ago • CCNPWhat is a solution to mitigate the MST misconfiguration caused by improper trunk link pruning?ITExamAnswers asked 4 years ago • CCNPRefer to the exhibit. A network administrator issues the show spanning-tree mst configuration command to verify the MST configuration. How many VLANs are assigned to IST?ITExamAnswers asked 4 years ago • CCNPWhat is a parameter that must match for all switches in the same MST region?ITExamAnswers asked 4 years ago • CCNP