IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPWhich two types of information can be extracted from the output of the show ip protocols command? (Choose two.)ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. Based on the provided debug aaa authorization and debug tacacs command output, which statement is true?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. Based on the debug aaa authentication and debug tacacs outputs, which statement is true?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. A legitimate user experienced a problem while attempting to gain access to the router EXEC shell. To investigate the situation, a network administrator issued debug tacacs and debug aaa authentication commands on the router. Based on the provided output, what could be the problem?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. Which statement about the debug radius authentication output is correct?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. A network administrator has recently implemented a GRE tunnel between the HQ router and a branch site. Whenever the GRE tunnel is activated, the indicated console messages are generated. Which two actions could fix this problem? (Choose two.)ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. A network administrator is attempting to connect a branch office to headquarters through a VPN tunnel. The tunnel is reported as being active at both ends, but the 10.2.2.0/24 network is not appearing in the routing table at the branch end. The administrator has determined that the problem is with the branch office configuration. Based on the output as shown, why is the 10.2.2.0/24 network not appearing in the routing table?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. A new system administrator is unable to obtain access to the EXEC shell. Based on the exhibited output of the debug aaa authorization command, what is the reason the administrator is unable to access the shell?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. A network technician has just configured router East to establish a tunnel to router West. After the configuration is applied, tunnel 1 is flapping. What needs to be done to stop this flapping?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. A network administrator wants to loadbalance the traffic that is coming from the LAN that is attached to router R1 and going to the 10.10.10.0/24 network. The output from the routing table on R1 reveals that the traffic is flowing through router R3 only. What is the reason for this traffic behavior?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. A network administrator has noticed that the IP SLA probe did not run as expected. What should the administrator do to correct this problem?ITExamAnswers asked 1 year ago • CCNPA network administrator needs to configure a router so that a path to the web server is only added to the routing table if the web server is available on port 8080. Which tool would provide this type of functionality?ITExamAnswers asked 1 year ago • CCNPWhen route redistribution is being configured from another routing protocol into EIGRP, what value is used when no seed metric is configured?ITExamAnswers asked 1 year ago • CCNPWhat is true of a switched virtual interface (SVI) on a Layer 3 switch?ITExamAnswers asked 1 year ago • CCNPA network administrator is troubleshooting the EIGRP configuration on a router. Which command would allow the administrator to display only the EIGRP configuration information in the running configuration file?ITExamAnswers asked 1 year ago • CCNP