IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPWhich three statements describe the building blocks that make up the IPsec protocol framework? (Choose three.)ITExamAnswers asked 3 years ago • CCNP, CCNAWhat two encryption algorithms are used in IPsec VPNs? (Choose two.)ITExamAnswers asked 4 years ago • CCNP, CCNARefer to the exhibit. Which two networks contain feasible successors? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNPWhich two aspects of the configuration of EIGRP for IPv6 differ from its configuration for IPv4? (Choose two.)ITExamAnswers asked 3 years ago • CCNA, CCNPRefer to the exhibit. Router R2 has recently been configured and connected via interface Gigabit Ethernet 0/0 to router R1. R1 is configured correctly, but fails to establish a neighbor relationship with R2. What is the problem?IT Administrator asked 3 years ago • CCNA, CCNPA network administrator has just changed the router ID on a router that is working in an OSPFv2 environment. What should the administrator do to reset the adjacencies and use the new router ID?ITExamAnswers asked 4 years ago • CCNA, CCNPWhen OSPFv2 neighbors are establishing adjacencies, in which state do they elect a DR and BDR router?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPRefer to the exhibit. Which address will R1 use as the source address for all OSPFv3 messages that will be sent to neighbors?ITExamAnswers asked 4 years ago • CCNA, CCNPWhat are the only two roles that permit an OSPF router to be configured for summarization? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNPWhat is the value used to determine which port on a non-root bridge will become a root port in a STP network?ITExamAnswers asked 4 years ago • CCNP, CCNAWhich IPv6 address is used by OSPFv3 as a next hop?ITExamAnswers asked 1 year ago • CCNPA switch console displays the message %SPANTREE2CHNL_MISCFG. What does this mean?ITExamAnswers asked 1 year ago • CCNPA network administrator types the following command on a router: Which response would most likely be displayed after issuing this command?ITExamAnswers asked 1 year ago • CCNPA network administrator is troubleshooting a connectivity issue in a Layer 2 switched network. After issuing the show macaddresstable command on the access switch, the administrator observes that there is no entry for the host that is experiencing the problems. The host machine is powered on and appears to be functioning normally. What can be deduced from this?ITExamAnswers asked 1 year ago • CCNPWhich three types of ports or interfaces can be affected by the Spanning Tree Protocol? (Choose three.)ITExamAnswers asked 1 year ago • CCNP