IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPRefer to the exhibit. A forwarding loop has been created between switches A, B, and D. Given the output generated by the show spanning-tree vlan command on switches B and D, what could be the cause of the problem?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. A network administrator is unable to ping between two workstations, PC1 and PC2, that are connected to switch3548. PC1 is connected to port Fa0/23, and PC2 is connected to port Gi0/2. Given the output of the show vlan command, which statement is true?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. Which two conclusions can be made based on the output of the show mac address-table command?(Choose two.)ITExamAnswers asked 1 year ago • CCNPA router is currently running both OSPF and BGP. The administrator issues the command show ip route | exclude ^B. What routes will be displayed?ITExamAnswers asked 1 year ago • CCNPWhich two features apply to MSTP? (Choose two.)ITExamAnswers asked 1 year ago • CCNPHow do you configure a specific interface for EIGRP in IPv6?ITExamAnswers asked 1 year ago • CCNPWhich command enables you to display the IPv6 BGP table?ITExamAnswers asked 1 year ago • CCNPHow can you include an interface into an OSPFv3 process for IPv4 address family?ITExamAnswers asked 1 year ago • CCNPWhich command enables you to display IPv6 – MAC mappings on the router?ITExamAnswers asked 1 year ago • CCNPWhich IP address is used as destination IP address for Hello messages when OSPFv3 is used to transfer IPv4 routes?ITExamAnswers asked 1 year ago • CCNPWhich LSA type is used to advertise external routes in OSPFv3?ITExamAnswers asked 1 year ago • CCNPWhich CLI commands will enable OSPFv3 authentication? (Choose two.)ITExamAnswers asked 1 year ago • CCNPWhich feature serves to offset the lack of authentication available with IEEE 802.1D Spanning Tree Protocol?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. After a major network upgrade, network users complain about poor video application performance. A network administrator verifies that all trunk links are up and operational and the EtherChannel configuration is correct. The output of the show interfaces port-channel command reveals that there is a 0 packet output rate over the last 5 minutes on the Po2 uplink. What could be done to correct the issue?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. A network administrator is replacing an existing router and configuring EIGRP authentication on the Serial 0/0/0 port. When viewing the routing table, the administrator notices that the entries for the remote networks are not listed. The administrator enters the debug eigrp packet command and notices this output: Based on the information in the running configuration and the output from the debug command, what is a possible reason for the missing routes?ITExamAnswers asked 1 year ago • CCNP