IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNP
Refer to the exhibit. An administrator wants EIGRP on Router1 to load balance traffic to network 2001:db8:11:10::/64 across two interfaces. Currently traffic is using only interface GigabitEthernet0/1. A second route, not in the routing table, is available with a metric of 264000. What value is needed in the variance command to make EIGRP put the second route into the routing table?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
Refer to the exhibit. Routers R1 and R2 enable EIGRP on all of their interfaces. Which two conclusions can the field engineer draw from the outputs of the show ip route eigrp command on each router? (Choose two.)
IT Questions Bank 3IT Administrator asked 3 years ago • 
Refer to the exhibit. An administrator has entered the command default-information originate in OSPFv3 global configuration mode on R1, but R2 is not receiving a default route. What is the problem?
IT Questions Bank 3IT Administrator asked 3 years ago • 
Refer to the exhibit. Routers R1 and R2 are configured as shown. However, the show ipv6 ospf neighbor command reveals that there are no OSPFv3 neighbors established. What error in the configuration is preventing neighbor relationship from forming between the two routers?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. A network administrator has configured two-way redistribution on router R1. However, OSPF routes are not being redistributed into the EIGRP domain. What is causing this issue?
IT Questions Bank 3IT Administrator asked 3 years ago • 
What OSPF LSA type is used to advertise routes redistributed into an OSPF domain?
IT Questions Bank 3IT Administrator asked 3 years ago • 
Match the IPsec function with the description.
IT Questions Bank 3IT Administrator asked 3 years ago • 
Match the IPsec function with its description. (Not all options are used.)
IT Questions Bank 3IT Administrator asked 3 years ago • 
Refer to the exhibit. Considering that R2, R3, and R4 are correctly configured, why did R1 not establish an adjacency with R2, R3, and R4?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
A network administrator is writing a standard ACL that will deny any traffic from the 172.16.0.0/16 network, but permit all other traffic. Which two commands should be used? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
Refer to the exhibit. Which two routes will be advertised to the router ISP if autosummarization is disabled? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
Refer to the exhibit. All networks are active in the same EIGRP routing domain. When the auto-summary command is issued on R3, which two summary networks will be calculated on R3? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
What information is maintained in the CEF adjacency table?
IT Questions Bank 3IT Administrator asked 3 years ago • 
Which NHRP message type notifies routers of routes used by NHRP that are no longer available?
IT Questions Bank 3IT Administrator asked 3 years ago • 
Refer to the exhibit. A network administrator is configuring Phase 1 DMVPN. The hub router RH1 and the spoke router RS2 are already configured and the administrator is finalizing configurations on spoke router RS3 by mapping the NHRP and NHS addresses for the DMVPN hub. Which configuration should the administrator use for the ip nhrp map command?
IT Questions Bank 3IT Administrator asked 3 years ago • 
« Previous1…6970717273…133Next »
Ask Question