IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPOSPFv3 authentication supports IPsec AH authentication using the ospfv3 authentication command. In which two instances can the authentication configuration be applied? (Choose two.)ITExamAnswers asked 3 years ago • CCNPWhich two statements are true when OSPFv3 with address families is used on routers connecting both IPv4 and IPv6 networks? (Choose two.)ITExamAnswers asked 3 years ago • CCNPOSPFv3 has three LSA flooding scope types. In addition to area scope what are the other two flooding scopes? (Choose two.)ITExamAnswers asked 3 years ago • CCNPWhich global configuration command will start OSPFv3 address families routing on a Cisco router?ITExamAnswers asked 3 years ago • CCNPThe LS Type field in OSPFv3 LSAs has been increased from 8 bits to 16 bits. What is a purpose of two of the high-order bits in this extended field?ITExamAnswers asked 3 years ago • CCNPWhat is the result of a router being configured with OSPFv3 for IPv6 when no explicit RID is configured and there are no active IPv4 interfaces?ITExamAnswers asked 3 years ago • CCNPWhen configuring OSPFv3 summarization, on which router should summarization be configured?ITExamAnswers asked 4 years ago • CCNPWhich two OSPFv3 LSA types are used to advertise IPv6 unicast address prefixes and prevent the need for SPF calculations every time an address prefix is added or changed on a router interface? (Choose two.)ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. A company has migrated from single area OSPF to multiarea. However, none of the users from network 192.168.1.0/24 in the new area can be reached by anyone in the Branch1 office. From the output in the exhibit, what is the problem?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. How did this router learn of the highlighted route in the routing table?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. A network administrator has configured OSPFv2 on the two Cisco routers as shown. PC1 is unable to connect to PC2. What should the administrator do first when troubleshooting the OSPFv2 implementation?ITExamAnswers asked 4 years ago • CCNPRefer to the exhibit. A network administrator issued the command show ip ospf interface on the router R2. What conclusion can be drawn?ITExamAnswers asked 4 years ago • CCNPRefer to the exhibit. In this scenario, Area 40 cannot be connected directly to Area 0. Which OSPF network type must be configured in Area 1 to connect these areas?ITExamAnswers asked 4 years ago • CCNA, CCNPIn an OSPF hub-and-spoke topology, what needs to be done, if anything, to ensure that the spoke routers would never be selected as DR and BDR?ITExamAnswers asked 3 years ago • CCNPA network engineer has noted that some expected network route entries are not displayed in the routing table. Which two commands will provide additional information about the state of router adjacencies, timer intervals, and the area ID? (Choose two.)IT Administrator asked 4 years ago • CCNP