IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNP
A network administrator is assigned the 172.16.0.0/24 block of addresses to use in designing an IP addressing scheme. The administrator submits this design for approval. What should be the response from the senior network engineer regarding this design?
IT Questions Bank 2IT Administrator asked 3 years ago • 
A network administrator is configuring a prefix list with the ip prefix-list command. Which entry is valid?
IT Questions Bank 2IT Administrator asked 3 years ago • 
A network administrator configures uRPF on a Cisco router interface with the ip verify unicast source reachable-via rx allow-default command to eliminate spoofed IP packets on a network. Which conclusion can be drawn from this configuration?
IT Questions Bank 2IT Administrator asked 3 years ago • 
Refer to the exhibit. The administrator configured the access to the console and the vty lines of a router. Which conclusion can be drawn from this configuration?​
IT Questions Bank 2IT Administrator asked 3 years ago • 
A network engineer has issued the following configuration commands What outcome is expected from the commands issued?
IT Questions Bank 2IT Administrator asked 3 years ago • 
A network engineer has issued the show run | section router eigrp command. What outcome is expected from the command output?
IT Questions Bank 2IT Administrator asked 3 years ago • 
What is the default OSPF seed metric for routes redistributed from BGP?
IT Questions Bank 2IT Administrator asked 3 years ago • 
Which two statements describe default behaviors of route redistribution? (Choose two.)
IT Questions Bank 2IT Administrator asked 3 years ago • 
A network administrator issues the show bgp ipv4 unicast summary command on a router to check the adjacency state with a neighbor router. The value under the State/PfxRcd field shows Active. Which statement describes the status of adjacency between the two routers?
IT Questions Bank 2IT Administrator asked 3 years ago • 
Which two statements describe private BGP communities? (Choose two.)
IT Questions Bank 2IT Administrator asked 3 years ago • 
What are two reasons why all IBGP routers in a single AS must be in a full mesh topology? (Choose two.)
IT Questions Bank 2IT Administrator asked 3 years ago • 
Refer to the exhibit. Which configuration on R1 would advertise a summary route of the two LANs to R2?
IT Questions Bank 13ITExamAnswers asked 4 years ago • 
Refer to the exhibit of the routing table from a router that is a backbone router and the ABR router for area 1. How will this routing table change, if any, if area 1 is configured as a stub area?
IT Questions Bank 2IT Administrator asked 3 years ago • 
An administrator is troubleshooting two routers in an EIGRPv6 network. A route filter was applied on one of the routers and since then, routes are no longer being populated as expected. What two commands can be used to verify that the filter was applied correctly and to display the IPv6 prefix list? (Choose two.)
IT Questions Bank 2IT Administrator asked 3 years ago • 
Which address will EIGRP for IPv6 use as the router ID?
IT Questions Bank 2IT Administrator asked 3 years ago • 
« Previous1…7879808182…133Next »
Ask Question