IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPRefer to the exhibit. Router R1 has recently been configured to operate in an IPv6 only network and is connected via interface Gigabit Ethernet 0/0 to router R2. R2 is configured correctly, but will not form a neighbor relationship with R1 What is the problem?IT Administrator asked 3 years ago • CCNPRefer to the exhibit. Which set of commands will configure static routes that will allow the Park and the Alta routers to a) forward packets to each LAN and b) direct all other traffic to the Internet?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. A network administrator is configuring a router for DHCPv6 operation. Which conclusion can be drawn based on the commands?ITExamAnswers asked 4 years ago • CCNA, CCNPA company has decided to implement VXLANs. What are two types of VTEP interfaces that will be deployed? (Choose two.)IT Administrator asked 3 years ago • CCNPHow does an antenna add gain to a wireless signal?IT Administrator asked 3 years ago • CCNPRefer to the exhibit. R1 is configured for NAT as displayed. What is wrong with the configuration?ITExamAnswers asked 4 years ago • CCNA, CCNPWhich type of OSPF link-state advertisement advertises redistributed routes in NSSAs?IT Administrator asked 3 years ago • CCNPRefer to the exhibit. A network administrator issues the show ip protocols command. Based on the exhibited output, what can be concluded?ITExamAnswers asked 4 years ago • CCNA, CCNPWhich factor can be used by an AP to improve the accuracy of locating a wireless client?ITExamAnswers asked 3 years ago • CCNPWhat does BGP use to exchange routing updates with neighbors?ITExamAnswers asked 3 years ago • CCNPWhich two methods are used by a single-root I/O virtualization (SR-IOV) enabled switch to switch traffic between VNFs? (Choose two.)ITExamAnswers asked 3 years ago • CCNPA company deploys a Cisco wireless network over a large campus. A network administrator is configuring the Layer 3 roaming capability on WLCs. What is the purpose of using Layer 3 roaming?IT Administrator asked 3 years ago • CCNPWhich special-purpose mode is configured on a lightweight AP that is acting as a dedicated sensor while determining the position of stations using location-based services?IT Administrator asked 3 years ago • CCNPWhat determines the software image release that a lightweight access point will be running?IT Administrator asked 3 years ago • CCNPWhich parameter must match for all switches in the same MST region?IT Administrator asked 3 years ago • CCNP