Refer to the exhibit. A Layer 3 switch routes for three VLANs and connects to a router for Internet connectivity. Which two configurations would be applied to the switch? (Choose two.)

Question:
Refer to the exhibit. A Layer 3 switch routes for three VLANs and connects to a router for Internet connectivity. Which two configurations would be applied to the switch? (Choose two.)

config)# interface gigabitethernet1/1
(config-if)# switchport mode trunk

(config)# interface gigabitethernet 1/1
(config-if)# no switchport
(config-if)# ip address 192.168.1.2 255.255.255.252

(config)# interface vlan 1
(config-if)# ip address 192.168.1.2 255.255.255.0
(config-if)# no shutdown

(config)# interface fastethernet0/4
(config-if)# switchport mode trunk

(config)# ip routing

Explanation: The no switchport command allows a switch port to be assigned an IP address. The port is a routed port at that point. The ip routing command enables routing for a switch. Use the interface vlan x command on the switch to configure routing for any VLAN that is attached to the switch, including the management VLAN. No management VLAN is shown in this scenario, but the commands interface vlan 5 and interface vlan 6, along with an appropriate IP address and subnet mask for each VLAN, would be used on the switch in the exhibit. There is no need to add an IP address or use the no shutdown command on VLAN 1 because VLAN 1 is not used in this design and because VLAN 1 is "up and up" by default.

Exam with this question: CCNA 3 Practice Final Exam Answers
Exam with this question: Switching, Routing, and Wireless Essentials ( Version 7.00) - SRWE Final Exam
Exam with this question: CCNA 2 (v5.0.3 + v6.0) Practice Final Exam Answers