Refer to the exhibit. R1 is configured properly for a single area OSPF, and R2 has been recently installed in the network. Which set of commands is required to configure a single area OSPF for the networks that are connected to R2?

IT Questions BankCategory: CCNA 2 v4Refer to the exhibit. R1 is configured properly for a single area OSPF, and R2 has been recently installed in the network. Which set of commands is required to configure a single area OSPF for the networks that are connected to R2?

Refer to the exhibit. R1 is configured properly for a single area OSPF, and R2 has been recently installed in the network. Which set of commands is required to configure a single area OSPF for the networks that are connected to R2? 

  • R2(config)# router ospf 1 R2(config-router)# network 192.168.2.0 0.0.0.255 area 0 R2(config-router)# network 10.1.1.0 0.0.0.3 area 0
  • R2(config)# router ospf 1 R2(config-router)# network 192.168.2.0 0.0.0.255 area 0 R2(config)# router ospf 2 R2(config-router)# network 10.1.1.0 0.0.0.3 area 0
  • R2(config)# router ospf 1 R2(config-router)# network 192.168.2.0 0.0.0.255 area 0 R2(config-router)# network 10.1.1.0 0.0.0.3 area 1
  • R2(config)# router ospf 1 R2(config-router)# network 192.168.2.0 0.0.0.255 area 0 R2(config-router)# network 10.0.0.0 0.0.0.3 area 1

Explanation: To configure R2 for OSPF in area 0 first enable OSPF with the router ospf 1 command. Then apply OSPF to the serial and LAN interfaces with the network 192.168.2.0 0.0.0.255 area 0 and network 10.1.1.0 0.0.0.3 area 0 commands.

Exam with this question: Quiz - OSPF
Exam with this question: CCNA Exploration 2: ERouting Final Exam

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments