Refer to the exhibit. What command would be used to configure a static route on R1 so that traffic from both LANs can reach the 2001:db8:1:4::/64 remote network?

Jul 10, 2020 Last Updated: May 30, 2021 No Comments
Tweet Share Pin it
IT Questions Bank › Category: CCNA › Refer to the exhibit. What command would be used to configure a static route on R1 so that traffic from both LANs can reach the 2001:db8:1:4::/64 remote network?

Question:
Refer to the exhibit. What command would be used to configure a static route on R1 so that traffic from both LANs can reach the 2001:db8:1:4::/64 remote network?
What command would be used to configure a static route on R1 so that traffic from both LANs can reach the 2001:db8:1:4::/64 remote network

  • ipv6 route ::/0 serial0/0/0
  • ipv6 route 2001:db8:1:4::/64 2001:db8:1:3::1
  • ipv6 route 2001:db8:1:4::/64 2001:db8:1:3::2
  • ipv6 route 2001:db8:1::/65 2001:db8:1:3::1

Explanation: To configure an IPv6 static route, use the ipv6 route command followed by the destination network. Then add either the IP address of the adjacent router or the interface R1 will use to transmit a packet to the 2001:db8:1:4::/64 network.

Exam with this question: CCNA Security Pretest Exam Answers
Exam with this question: CCNA 2 (v5.0.3 + v6.0) Chapter 2 Exam Answers
Exam with this question: CCNA 2 (v5.0.3 + v6.0) Chapter 6 Exam Answers

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments