What command will enable a router to begin sending messages that allow it to configure a link-local address without using an IPv6 DHCP server?

Question:
What command will enable a router to begin sending messages that allow it to configure a link-local address without using an IPv6 DHCP server?

• a static route
• the ipv6 route ::/0 command
• the ipv6 unicast-routing command
• the ip routing command

Explanation: To enable IPv6 on a router you must use the ipv6 unicast-routing global configuration command or use the ipv6 enable interface configuration command. This is equivalent to entering ip routing to enable IPv4 routing on a router when it has been turned off. Keep in mind that IPv4 is enabled on a router by default. IPv6 is not enabled by default.

Exam with this question: CCNA 2 v7 Course Final Exam Answers
Exam with this question: CCNA 2 (v5.0.3 + v6.0) Chapter 4 Exam Answers
Exam with this question: CCNA 2 (v5.0.3 + v6.0) Practice Final Exam Answers
Exam with this question: CCNA 2 v6 Chapter 1: Check Your Understanding