IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v4A network administrator has configured a default route on Router_A but it is not being shared with adjacent Router_B and the other routers in the OSPF area. Which command will save the administrator the time and trouble of configuring this default route on Router_B and all of the other routers in the OSPF area?ITExamAnswers asked 8 months ago • CCNA 2 v4Refer to the exhibit. What are the effects of the exhibited commands on the router?ITExamAnswers asked 8 months ago • CCNA 2 v4On a router, which actions can be performed in user mode?ITExamAnswers asked 8 months ago • CCNA 2 v4If a router is booting with its default configuration register setting and its NVRAM lacks boot system commands, from where will the router try to load the IOS image first?ITExamAnswers asked 8 months ago • CCNA 2 v4What does RIP use to reduce convergence time in a larger network?ITExamAnswers asked 8 months ago • CCNA 2 v4Refer to the exhibit. Hosts on the BOS Fa0/0 LAN are able to ping the Fa0/1 interface on the JAX router and all interfaces on the BOS and ORL routers. Why would hosts from the 10.0.0.0/24 network not be able to ping hosts on the Fa0/0 LAN of the JAX router?ITExamAnswers asked 8 months ago • CCNA 2 v4What happens if an EIGRP network path fails and DUAL cannot locate a suitable successor?ITExamAnswers asked 8 months ago • CCNA 2 v4Refer to the exhibit. Which route will be removed from the routing table if manual EIGRP summarization is disabled the Serial0/0/0 interface of R3?ITExamAnswers asked 8 months ago • CCNA 2 v4The network shown in the diagram is having problems routing traffic. It is suspected that the problem is with the addressing scheme. What is the problem with the addressing used in the topology?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What happens to a packet that has 172.16.0.0/16 as the best match in the routing table that is shown?ITExamAnswers asked 2 years ago • CCNA 2 v4Which of the following could describe the devices labeled “?” in the graphic? (Choose three.)ITExamAnswers asked 8 months ago • CCNA 2 v4Refer to the exhibit. A network administrator has enabled RIP on routers B and C in the network diagram. Which of the following commands will prevent RIP updates from being sent to Router A?ITExamAnswers asked 2 years ago • CCNA 2 v4A network administrator enters the following command into Router1: ip route 192.168.0.0 255.255.255.0 S0/1/0. Router1 then receives a packet that is destined for 192.168.0.22/24. After finding the recently configured static route in the routing table, what does Router1 do next to process the packet?ITExamAnswers asked 2 years ago • CCNA 2 v4, CCNA 2 v5Which two statements describe characteristics of load balancing? (Choose two.)ITExamAnswers asked 3 years ago • CCNP, CCNA 2 v4, CCNA 2 v5Refer to the exhibit. What destination address will RTB use to advertise LSAs?IT Administrator asked 4 years ago • CCNP, CCNA 2 v4, CCNP ROUTE v6.0