IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 3 v4Which two statements are true regarding switch port security? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6, CCNA 2 v7, CCNA 3 v4Which three statements accurately describe VLAN types? (Choose three).ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v7, CCNA 3 v4Which statement is correct about STP architecture?ITExamAnswers asked 2 years ago • CCNA 3 v4What is a result of improperly implementing a network with redundancy at Layer 2?ITExamAnswers asked 2 years ago • CCNA 3 v4Which two devices can cause interference with the operation of a WLAN because they operate on similar frequencies? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. All edge ports are configured with the spanning-tree portfast command. Host1 is recently connected to port Fa0/1 on switch SW1. Which statement is true about the status of port Fa0/1?ITExamAnswers asked 4 years ago • CCNP, CCNA 3 v4What technique is a security attack that depletes the pool of IP addresses available for legitimate hosts?IT Administrator asked 4 years ago • CCNA CyberOps, CCNA 3 v4What allows WLAN clients to learn which networks and access points are available in an area?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. A technician is troubleshooting a trunk problem between switches SW1 and SW2. What should be done to remedy the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Although they are directly connected, switch SWA is not exchanging VLAN information with switch SWC. What can be done to correct this problem?ITExamAnswers asked 2 years ago • CCNA 3 v4When an access point is placed near the outside wall of a building, which implementation design procedure should be used?ITExamAnswers asked 2 years ago • CCNA 3 v4Which IEEE trunking protocol is used to encapsulate data traffic over a trunk link on a Cisco switch?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Switch SWB is not responding to VTP updates from switch SWA. What is a possible cause of the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. All switch interfaces are members of the same VLAN. What information is used by Switch1 to determine if incoming frames from the hosts should be forwarded to Router1?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The broadcast traffic from PC1 is consuming bandwidth on the interswitch trunks. What should be done to prevent this from happening?ITExamAnswers asked 2 years ago • CCNA 3 v4