IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA Discovery v4In which section of the Network Design Requirements document would a network consulting team detail names and IP addresses of important networking components and servers, provide network diagrams and topologies, and define strengths and weaknesses of the network?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. The network administrator is attempting to install a new version of the IOS on R2. Based on the exhibited output, what are two possible reasons that the transfer failed? (Choose two.)ITExamAnswers asked 8 months ago • CCNA Discovery v4During a wireless site survey, a consultant is determining the hours of peak usage and the estimated number of users in each location. The consultant is currently in what step of the site survey process?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. What two items can be determined from the output? (Choose two.)ITExamAnswers asked 8 months ago • CCNA Discovery v4A network design project includes a review of the existing network. What is the purpose of this phase of the project?ITExamAnswers asked 8 months ago • CCNA Discovery v4During a site survey, the network designer noticed that people were accessing the company wireless network from the parking lot. What should be done to stop the wireless signal from radiating out into the parking lot?ITExamAnswers asked 8 months ago • CCNA Discovery v4A production router is reloaded and finishes with a Router> prompt. What three facts can be determined? (Choose three.)ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. A network designer has no documentation and is attempting to create a logical diagram of the network using the output from show commands. What can be determined from the output shown?ITExamAnswers asked 8 months ago • CCNA Discovery v4A new Cisco IOS version has been copied into flash from a TFTP server. When a reload is issued to upgrade the Cisco IOS, the router freezes part of the way through the loading process. What could be the problem?ITExamAnswers asked 8 months ago • CCNA Discovery v4The new network design for AnyCompany must include support of voice and video traffic. Before upgrading, the network designer checks whether the existing devices can support the new requirements. Which three items does the designer need to check? (Choose three.)ITExamAnswers asked 8 months ago • CCNA Discovery v4An employee at a company notices that the wireless signal strength indicator on his laptop fluctuates from good to low. The network administrator decides to do a site survey of that area. Which three factors need to be included in the survey? (Choose three.)ITExamAnswers asked 8 months ago • CCNA Discovery v4A company is beginning to analyze their new Cisco IOS upgrade requirements. What is one of the router components that a network administrator must consider when selecting a new Cisco IOS version?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. Which two actions improve the weaknesses of the topology shown, assuming that each access layer segment is in its own subnet? (Choose two.)ITExamAnswers asked 8 months ago • CCNA Discovery v4Which two items are objectives of a WLAN design site survey? (Choose two.)ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. The top of the output shows the Cisco Feature Navigator regarding a Cisco IOS image that the administrator wants to install on a router. Below it is the output from the show version command for that router. Which statement is true regarding the capacity of the router to run this Cisco IOS image?ITExamAnswers asked 8 months ago • CCNA Discovery v4