Refer to the exhibit. R1 is configured for NAT as displayed. What is wrong with the configuration?

IT Questions BankCategory: CCNARefer to the exhibit. R1 is configured for NAT as displayed. What is wrong with the configuration?
Refer to the exhibit. R1 is configured for NAT as displayed. What is wrong with the configuration? 1ITExamAnswers Staff asked 11 months ago

Question:
Refer to the exhibit. R1 is configured for NAT as displayed. What is wrong with the configuration?

Refer to the exhibit. R1 is configured for NAT as displayed. What is wrong with the configuration? 2

  • NAT-POOL2 is not bound to ACL 1.
  • Interface Fa0/0 should be identified as an outside NAT interface.
  • The NAT pool is incorrect.
  • Access-list 1 is misconfigured.

Explanation: R1 has to have NAT-POOL2 bound to ACL 1. This is accomplished with the command R1(config)#ip nat inside source list 1 pool NAT-POOL2. This would enable the router to check for all interesting traffic and if it matches ACL 1 it would be translated by use of the addresses in NAT-POOL2.

More Questions: CCNA 3 v7.0 Final Exam Answers
More Questions: CCNA 2 (v5.0.3 + v6.0) Practice Final Exam Answers
More Questions: CCNP ENCOR Final Exam


Related Articles