IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAWhich statement describes a multiarea OSPF network?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNA 3 v7Which command will verify that a router that is running OSPFv3 has formed an adjacency with other routers in its OSPF area?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPA network administrator enters the command ipv6 router ospf 64 in global configuration mode. What is the result of this command?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhich three addresses could be used as the destination address for OSPFv3 messages? (Choose three.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhich wildcard mask would be used to advertise the 192.168.5.96/27 network as part of an OSPF configuration?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6What are the two purposes of an OSPF router ID? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhat is a function of OSPF hello packets?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNA 3 v7What is used to create the OSPF neighbor table?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6Which three statements describe features of the OSPF topology table? (Choose three.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPA router is participating in an OSPFv2 domain. What will always happen if the dead interval expires before the router receives a hello packet from an adjacent DROTHER OSPF router?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPA network administrator wants to verify the default delay values for the interfaces on an EIGRP-enabled router. Which command will display these values?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhich two parameters does EIGRP use by default to calculate the best path? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6When will a router that is running EIGRP put a destination network in the active state?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhich address is used by an IPv6 EIGRP router as the source for hello messages?ITExamAnswers asked 4 years ago • CCNA, CCNPWhich configuration is necessary to ensure successful operation of EIGRP for IPv6?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNP