A network administrator wants to verify the default delay values for the interfaces on an EIGRP-enabled router. Which command will display these values?

October 11, 2020 Last Updated: April 24, 2021 No Comments
Tweet Share Pin it
IT Questions Bank › Category: CCNA › A network administrator wants to verify the default delay values for the interfaces on an EIGRP-enabled router. Which command will display these values?
0
Vote Up
Vote Down
A network administrator wants to verify the default delay values for the interfaces on an EIGRP-enabled router. Which command will display these values? 1ITExamAnswers Staff asked 7 months ago

A network administrator wants to verify the default delay values for the interfaces on an EIGRP-enabled router. Which command will display these values?

  • show running-config
  • show ip protocols
  • show interfaces
  • show ip route

Explanation: The show interfaces command is used to show the delay, in microseconds, of a specified interface. This command will also provide the default delay value or an administratively configured value. The show running-config command will only display an administratively configured value. The commands show ip route and show ip protocols will not provide the delay value of each interface.

More Questions: CCNA 3 (v5.0.3 + v6.0) Chapter 6 Exam Answers
More Questions: CCNP Enterprise: Advanced Routing (Version 8.0) – Routing Concepts and EIGRP Exam


Related Articles