IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAWhat is the multicast address used by an EIGRP-enabled router operating with IPv6?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6What information does EIGRP maintain within the routing table?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6If all router Ethernet interfaces in an EIGRP network are configured with the default EIGRP timers, how long will a router wait by default to receive an EIGRP packet from its neighbor before declaring the neighbor unreachable?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhich two factors are important when deciding which interior gateway routing protocol to use? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6Which statement describes a route that has been learned dynamically?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6Which routing protocol is limited to smaller network implementations because it does not accommodate growth for larger networks?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6Which dynamic routing protocol was developed to interconnect different Internet service providers?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhat is the purpose of HSRP?ITExamAnswers asked 4 years ago • CCNP, CCNA, CCNA 3 v6Which two protocols are link aggregation protocols? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6Which two load balancing methods can be implemented with EtherChannel technology? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6Which two concepts relate to a switch port that is intended to have only end devices attached and intended never to be used to connect to another switch? (Choose two.)ITExamAnswers asked 4 years ago • CCNP, CCNA, CCNA 3 v6What value determines the root bridge when all switches connected by trunk links have default STP configurations?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6Which two network design features require Spanning Tree Protocol (STP) to ensure correct network operation? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhich STP priority configuration would ensure that a switch would always be the root switch?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhich is the default STP operation mode on Cisco Catalyst switches?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6