IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAWhich STP port role is adopted by a switch port if there is no other port with a lower cost to the root bridge?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6What additional information is contained in the 12-bit extended system ID of a BPDU?ITExamAnswers asked 4 years ago • CCNP, CCNA, CCNA 3 v6Which two functions are performed at the MAC sublayer of the OSI Data Link Layer to facilitate Ethernet communication? (Choose two.)ITExamAnswers asked 4 years ago • CCNAWhat is the Cisco IOS?ITExamAnswers asked 2 years ago • CCNA, Network FundamentalsWhat must an administrator have in order to reset a lost password on a router?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6, CCNA 3 v7What information can be gathered about a neighbor device from the show cdp neighbors detail command that cannot be found with the show cdp neighbors command?IT Administrator asked 3 years ago • CCNA, CCNA 2 v6When dynamic NAT without overloading is being used, what happens if seven users attempt to access a public server on the Internet when only six addresses are available in the NAT pool?ITExamAnswers asked 4 years ago • CCNP, CCNA, CCNA 2 v6Which statement accurately describes dynamic NAT?IT Administrator asked 3 years ago • CCNA, CCNA 2 v6, CCNA Security, DevNet, Networking EssentialsWhat is a disadvantage of NAT?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6Which type of NAT maps a single inside local address to a single inside global address?IT Administrator asked 4 years ago • CCNA, CCNA 2 v6, CCNA 3 v7Which version of NAT allows many hosts inside a private network to simultaneously use a single inside global address for connecting to the Internet?IT Administrator asked 3 years ago • CCNA, CCNA 2 v6What is used in the EUI-64 process to create an IPv6 interface ID on an IPv6 enabled interface?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6, CCNA 2 v7How does an IPv6 client ensure that it has a unique address after it configures its IPv6 address using the SLAAC allocation method?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6A company implements the stateless DHCPv6 method for configuring IPv6 addresses on employee workstations. After a workstation receives messages from multiple DHCPv6 servers to indicate their availability for DHCPv6 service, which message does it send to a server for configuration information?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6Under which two circumstances would a router usually be configured as a DHCPv4 client? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6