IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAWhich IPv4 address range covers all IP addresses that match the ACL filter specified by 172.16.2.0 with wildcard mask 0.0.1.255?ITExamAnswers asked 4 years ago • CCNA, CCNPWhich term describes the role of a Cisco switch in the 802.1X port-based access control?IT Administrator asked 4 years ago • CCNP, CCNA, CCNA SecurityWhat device is considered a supplicant during the 802.1X authentication process?ITExamAnswers asked 4 years ago • CCNP, CCNA, CCNA SecurityWhich protocol defines port-based authentication to restrict unauthorized hosts from connecting to the LAN through publicly accessible switch ports?ITExamAnswers asked 4 years ago • CCNA, CCNA SecurityWhat is the behavior of a switch as a result of a successful CAM table attack?ITExamAnswers asked 4 years ago • CCNA, CCNA SecurityWhich protocol should be used to mitigate the vulnerability of using Telnet to remotely manage network devices?ITExamAnswers asked 4 years ago • CCNA, CCNA SecurityA network administrator is analyzing the features supported by the multiple versions of SNMP. What are two features that are supported by SNMPv3 but not by SNMPv1 or SNMPv2c? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA SecurityWhich syslog message type is accessible only to an administrator and only via the Cisco CLI?ITExamAnswers asked 4 years ago • CCNA, CCNA SecurityOn which two interfaces or ports can security be improved by configuring executive timeouts? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA SecurityWhich command will block login attempts on RouterA for a period of 30 seconds if there are 2 failed login attempts within 10 seconds?ITExamAnswers asked 4 years ago • CCNA, CCNA SecurityWhat is used by BGP to determine the best path to a destination?ITExamAnswers asked 4 years ago • CCNA, CCNPWhich command can be used by an administrator to display a list of interfaces that are enabled for OSPFv3?ITExamAnswers asked 4 years ago • CCNA, CCNPAfter implementing an IPv6 network, the administrator notices that the OSPFv3 process is not starting on the routers. What could be the problem?ITExamAnswers asked 4 years ago • CCNA, CCNPA network engineer is troubleshooting a single-area OSPFv3 implementation across routers R1, R2, and R3. During the verification of the implementation, it is noted that the routing tables on R1 and R2 do not include the entry for a remote LAN on R3. Examination of R3 shows the following:ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. Which would be chosen as the router ID of R2?ITExamAnswers asked 4 years ago • CCNA, CCNP