IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAIn what two situations would UDP be better than TCP as the preferred transport protocol? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, DevNet, IT EssentialsRefer to the exhibit. A company has migrated from single area OSPF to multiarea. However, none of the users from network 192.168.1.0/24 in the new area can be reached by anyone in the Branch1 office. From the output in the exhibit, what is the problem?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. How did this router learn of the highlighted route in the routing table?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. In this scenario, Area 40 cannot be connected directly to Area 0. Which OSPF network type must be configured in Area 1 to connect these areas?ITExamAnswers asked 4 years ago • CCNA, CCNPA network administrator is measuring the transfer of bits across the company backbone for a mission critical financial application. The administrator notices that the network throughput appears lower than the bandwidth expected. Which three factors could influence the differences in throughput? (Choose three.) answered 4 years ago • CCNARefer to the exhibit. An administrator is attempting to install an IPv6 static route on router R1 to reach the network attached to router R2. After the static route command is entered, connectivity to the network is still failing. What error has been made in the static route configuration?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. Router CiscoVille has been partially configured for EIGRP authentication. What is missing that would allow successful authentication between EIGRP neighbors?ITExamAnswers asked 4 years ago • CCNA, CCNPVoice packets are being received in a continuous stream by an IP phone, but because of network congestion the delay between each packet varies and is causing broken conversations. What term describes the cause of this condition?ITExamAnswers asked 4 years ago • CCNAOn which port should Dynamic ARP Inspection (DAI) be configured on a switch?IT Administrator asked 4 years ago • CCNA, CCNA SecurityRefer to the exhibit. Router R1 was configured by a network administrator to use SNMP version 2. The following commands were issued: Why is the administrator not able to get any information from R1?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. An administrator wants EIGRP on Router1 to load balance traffic to network 2001:db8:11:10::/64 across two interfaces. Currently traffic is using only interface GigabitEthernet0/1. A second route, not in the routing table, is available with a metric of 264000. What value is needed in the variance command to make EIGRP put the second route into the routing table?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. Considering that R2, R3, and R4 are correctly configured, why did R1 not establish an adjacency with R2, R3, and R4?ITExamAnswers asked 4 years ago • CCNA, CCNPA network administrator is writing a standard ACL that will deny any traffic from the 172.16.0.0/16 network, but permit all other traffic. Which two commands should be used? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. Which two routes will be advertised to the router ISP if autosummarization is disabled? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. All networks are active in the same EIGRP routing domain. When the auto-summary command is issued on R3, which two summary networks will be calculated on R3? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNP