IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPRefer to the exhibit. The web servers WS_1 and WS_2 need to be accessed by external and internal users. For security reasons, the servers do not have to communicate with each other although they are located on the same subnet. Both servers need to communicate with the data server that is located on the inside network. Which configuration will isolate the servers from inside attacks?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0Refer to the exhibit. Which option correctly describes the function of a switch that is configured in VTP transparent mode?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0Which two items are benefits of implementing local VLANs within the Enterprise Architecture? (Choose two.)ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0Which three effects does the interface command switchport host have when entered on a switch? (Choose three.)ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0A network administrator is tasked with protecting a server farm by implementing private VLANs (PVLANs). A server is only allowed to communicate with its default gateway and other related servers. Which type of PVLAN should be configured on the switch ports that connect to the servers?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0Refer to the exhibit. Switch SW2 was tested in a lab environment and later inserted into the production network. Before the trunk link was connected between SW1 and SW2, the network administrator issued the show vtp status command as displayed in the exhibit. Immediately after the switches were interconnected, all users lost connectivity to the network. What could be a possible reason for the problem?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0What are three characteristics of a VLAN access port? (Choose three.)IT Administrator asked 3 years ago • CCNP, CCNP SWITCH v6.0Refer to the exhibit. Both SW1 and SW2 are configured with the PAgP desirable mode. Which statement is true?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0What IPsec service verifies that the data was not altered during transmission?ITExamAnswers asked 3 years ago • CCNP, CCNP ROUTE v6.0Which three protocols are involved in the establishment of an IPsec VPN tunnel? (Choose three.)IT Administrator asked 3 years ago • CCNP, CCNP ROUTE v6.0Refer to the exhibit. A network administrator in autonomous system 65100 has set up a dual-homed BGP connection with an ISP. The administrator would like to ensure that all traffic from the ISP enters the autonomous system through the router R1. Which BGP attribute can the administrator configure on routers R1 and R2 to accomplish this?IT Administrator asked 3 years ago • CCNP, CCNP ROUTE, CCNP ROUTE v6.0, DevNetWhich BGP attribute is used by BGP to ensure a loop-free topology on the Internet?ITExamAnswers asked 4 years ago • CCNP, CCNP ROUTE, CCNP ROUTE v6.0Refer to the exhibit. Autonomous system 65500 is routing traffic between two external BGP autonomous systems, autonomous system 65200 and autonomous system 65100. Synchronization is disabled on BGP in autonomous system 65500. Which routers should have IBGP peer relationships for routing between autonomous system 65200 and autonomous system 65100 to work properly?IT Administrator asked 4 years ago • CCNP, CCNP ROUTE, CCNP ROUTE v6.0Refer to the exhibit. BGP sessions are established between all routers. RTC receives route updates for network 209.165.200.224/27 from autonomous system 300 with the weight attribute set to 3000. RTB also learns about network 209.165.200.224/27 from autonomous system 200 with a weight of 2000. Which router will be used by RTA as a next hop to reach this network?ITExamAnswers asked 3 years ago • CCNP, CCNP ROUTE, CCNP ROUTE v6.0Which BGP routers will become peers and share routing information?IT Administrator asked 4 years ago • CCNP, CCNA 4 v6, CCNP ROUTE, CCNP ROUTE v6.0