IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPWhat is the recommended maximum one-way jitter when implementing video over IP for real-time video applications?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. Switches DSw1 and DSw2 are configured with the HSRP virtual IP address 10.10.10.1, and standby priority is set to 100. Assume both switches finish booting at the same time and HSRP is operating as expected. On the basis of this information, which three HSRP statements are true? (Choose three.)ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. Assuming that the switch is running Multiple Spanning Tree (MST), which conclusion can be made based on the output?ITExamAnswers asked 3 years ago • CCNPWhich three actions are taken when the command switchport host is entered on a switch port? (Choose three.)ITExamAnswers asked 3 years ago • CCNPA network administrator wants to implement inter-VLAN routing in the network. Which interfaces should be configured as routed ports?ITExamAnswers asked 3 years ago • CCNPWhat are two actions a hacker may take in a VLAN hopping attack? (Choose two.)ITExamAnswers asked 3 years ago • CCNPWhich STP enhancement should be configured in the network to prevent a nondesignated port to transition to a forwarding state when a topology change occurs?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. The exhibit contains the configuration for a Cisco access device. How will someone dialing in be authenticated?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. What is the problem between the connection on Switch1 and Switch2?ITExamAnswers asked 3 years ago • CCNPWhat type of queuing provides the best quality for voice applications?ITExamAnswers asked 4 years ago • CCNPWhat are three possible misconfigurations or indicators of misconfigurations on a Layer 3 interface? (Choose three.)ITExamAnswers asked 3 years ago • CCNPWhich two procedures should be implemented and in place when deploying VoIP in a campus network? (Choose two.)ITExamAnswers asked 3 years ago • CCNPHow should a switch port be configured for a connection to a standalone wireless access point that provides multiple VLAN-separated SSIDs?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. What happens if interface gigabitEthernet 5/1 on SwitchA stops receiving UDLD packets?ITExamAnswers asked 1 year ago • CCNPWhen troubleshooting GLBP in an environment with a VLAN that spans multiple access layer switches, a network engineer discovers that suboptimal paths are being used for upstream traffic. What is the recommended solution?ITExamAnswers asked 3 years ago • CCNP