IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPWhich QoS requirement should be taken into account when implementing VoIP in a campus environment?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. What two conclusions can be made based on the output? (Choose two.)ITExamAnswers asked 3 years ago • CCNPWhich three actions can cause problems with a VTP implementation? (Choose three.)ITExamAnswers asked 4 years ago • CCNPA bridging loop occurs in a network and disrupts user connectivity. What action should be taken by a network administrator to restore connectivity?ITExamAnswers asked 3 years ago • CCNPWhich three steps are required to configure interfaces as routed ports on a multilayer Catalyst switch? (Choose three.)ITExamAnswers asked 3 years ago • CCNPWhen a port security violation occurs on a switch port, the switch sends a syslog message but does not shut down the port. What port security mode is in effect?ITExamAnswers asked 3 years ago • CCNPWhich statement is true concerning the core layer within the hierarchical design model?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. What feature does an SNMP manager need to be able to set a parameter on ACSw1?ITExamAnswers asked 3 years ago • CCNPWhich statement correctly explains the process of mitigating ARP attacks on a switch where dynamic ARP inspection (DAI) has been configured?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. The indicated configuration was established on the HSRP standby router RTB. However, the console message %IP-4-DUPADDR started appearing almost immediately on the RTB router. Given the output of the show standby brief command on RTA, what is the cause of the problem?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. A network administrator is configuring BGP route advertisement on router R1. The network 10.1.0.0/24 is subnetted into four 10.1.0.0/26 subnets that are attached to the 4 interfaces of R1 respectively. The administrator issues the show ip route command and notices that the network 10.1.0.0/24 is not advertised by BGP. What is a possible cause for this issue?IT Administrator asked 3 years ago • CCNPRefer to the exhibit. Router R0-A is not learning all of the OSPF routes from the remote sites that connect to router R0-B and R0-C. What are two issues the network engineer should consider? (Choose two.)IT Administrator asked 3 years ago • CCNPA network administrator is configuring an ACL to match networks for BGP route filtering. The administrator creates an ACE permit ip 10.0.32.0 0.0.31.0 255.255.255.0 0.0.0.192. Which network matches the ACE?ITExamAnswers asked 3 years ago • CCNPWhich are two characteristics of the stub feature in EIGRP ? (Choose two.)IT Administrator asked 1 year ago • CCNPAn administrator issued the following commands on router R1. What conclusion can be drawn from this configuration?IT Administrator asked 3 years ago • CCNA, CCNP