IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPWhich two statements correctly describe OSPF type 3 LSAs? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhich characteristic describes both ABRs and ASBRs that are implemented in a multiarea OSPF network?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhich command will verify that a router that is running OSPFv3 has formed an adjacency with other routers in its OSPF area?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPA network administrator enters the command ipv6 router ospf 64 in global configuration mode. What is the result of this command?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhich three addresses could be used as the destination address for OSPFv3 messages? (Choose three.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhat are the two purposes of an OSPF router ID? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhich three statements describe features of the OSPF topology table? (Choose three.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPA router is participating in an OSPFv2 domain. What will always happen if the dead interval expires before the router receives a hello packet from an adjacent DROTHER OSPF router?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPA network administrator wants to verify the default delay values for the interfaces on an EIGRP-enabled router. Which command will display these values?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhen will a router that is running EIGRP put a destination network in the active state?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhich address is used by an IPv6 EIGRP router as the source for hello messages?ITExamAnswers asked 4 years ago • CCNA, CCNPWhich configuration is necessary to ensure successful operation of EIGRP for IPv6?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPA new network administrator has been asked to verify the metrics that are used by EIGRP on a Cisco device. Which two EIGRP metrics are measured by using static values on a Cisco device? (Choose two.)ITExamAnswers asked 4 years ago • CCNP, CCNA 3 v6Which destination MAC address is used when a multicast EIGRP packet is encapsulated into an Ethernet frame?ITExamAnswers asked 4 years ago • CCNA 3 v6, CCNPIf all router Ethernet interfaces in an EIGRP network are configured with the default EIGRP timers, how long will a router wait by default to receive an EIGRP packet from its neighbor before declaring the neighbor unreachable?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNP