IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNP
A network administrator is troubleshooting an issue with a DMVPN tunnel. From the output of the show dmvpn command, the administrator notes that the tunnel is in the IPsec state. What problem does this state indicate?
IT Questions Bank 2IT Administrator asked 3 years ago • 
Refer to the exhibit. Which protocol is used by R2 and R5 to exchange Layer 3 routes?
IT Questions Bank 2IT Administrator asked 3 years ago • 
A network technician is verifying the OPSFv3 address families configuration on a Cisco router. What would the technician expect to see displayed when the show ospfv3 database router adv-router 4.4.4.4 command is issued?
IT Questions Bank 2IT Administrator asked 3 years ago • 
Refer to the exhibit. Routers R1 and R2 were configured with EIGRP message authentication, but the routers cannot exchange EIGRP messages. Which two problems are causing the EIGRP authentication failure between R1 and R2 in this configuration? (Choose two.)
IT Questions Bank 2IT Administrator asked 3 years ago • 
Which is a characteristic of policy based routing (PBR)?
IT Questions Bank 2IT Administrator asked 3 years ago • 
What is the purpose of the BGP maximum prefix feature?
IT Questions Bank 7ITExamAnswers asked 3 years ago • ,
Refer to the exhibit. A network administrator verifies on an enterprise network that EIGRP query packets are delayed because of packet loss. The administrator issues the show ip protocols | include Active command to see the EIGRP active timer on a router. What can the administrator conclude from this output?
IT Questions Bank 2IT Administrator asked 3 years ago • ,
Refer to the exhibit. A SNMP manager is using the community string of snmpenable and is configured with the IP address 172.16.10.1. The SNMP manager is unable to read configuration variables on the R1 SNMP agent. What could be the problem?
IT Questions Bank 2IT Administrator asked 3 years ago • ,
Refer to the exhibit. What is the function of the Null0 route in the outputs displayed for R1 and R2?
IT Questions Bank 2IT Administrator asked 3 years ago • ,
Refer to the exhibit. A network administrator has configured OFPF in the topology as shown. What is the preferred path to get from the LAN network that is connected to R1 to the LAN network that is connected to R7?
IT Questions Bank 7ITExamAnswers asked 4 years ago • ,
A network student has to prepare a paper about EIGRP network summarization, but the student does not know much about summarization metrics. What piece of information is accurate about EIGRP summarization?
IT Questions Bank 7ITExamAnswers asked 3 years ago • 
Refer to the exhibit. A network administrator is configuring an EtherChannel link between two switches, SW1 and SW2. Which statement describes the effect after the commands are issued on SW1 and SW2?
IT Questions Bank 7ITExamAnswers asked 4 years ago • ,
Refer to the exhibit. Spanning-tree port priorities are listed beneath each interface. The network administrator enters the spanning-tree vlan 1 root primary command on S4. What is the effect of the command?
IT Questions Bank 7ITExamAnswers asked 3 years ago • 
Refer to the exhibit. A junior administrator issues the show ip protocol command while troubleshooting missing NSSA OSPF routes. What is the most likely cause for the missing OSPF routes?
IT Questions Bank 7ITExamAnswers asked 3 years ago • 
Refer to the exhibit. Match the description to the corresponding value used by the DUAL FSM. (Not all options are used.)
IT Questions Bank 7ITExamAnswers asked 4 years ago • ,
« Previous1…3334353637…133Next »
Ask Question