IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: Network Fundamentals
Refer to the exhibit. Which set of devices contains only end devices?
IT Questions Bank 2ITExamAnswers asked 3 years ago • ,
What is the effect of using the Router# copy running-config startup-config command on a router?
IT Questions Bank 2ITExamAnswers asked 4 years ago • , ,
Immediately after a router completes its boot sequence, the network administrator wants to check the routers configuration. From privileged EXEC mode, which of the following commands can the administrator use for this purpose? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
Which portion of the network layer address does a router use to forward packets?
IT Questions Bank 5IT Administrator asked 3 years ago • , , ,
Refer to the exhibit. Which term correctly identifies the device type that is included in the area B?
IT Questions Bank 2ITExamAnswers asked 2 years ago • , ,
What is the Cisco IOS?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
What command can be used to troubleshoot domain name resolution issues?
IT Questions Bank 2ITExamAnswers asked 2 years ago • , ,
When a collision occurs in a network using CSMA/CD, how do hosts with data to transmit respond after the backoff period has expired?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
Refer to the exhibit. The switch and workstation are administratively configured for full-duplex operation. Which statement accurately reflects the operation of this link?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
The serial connection shown in the graphic needs to be configured. Which configuration commands must be made on the Sydney router to establish connectivity with the Melbourne site? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
What information is added during encapsulation at OSI Layer 3?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
Refer to the exhibit. What is the total amount of RAM on the router?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
UDP is the transport layer protocol for which application?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
A network technician wants to configure an IP address on a router interface by using the ip address 192.168.1.1 255.255.255.0 command. Which prompt should the technician see when entering this command?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which statement is true about Layer 3 addresses?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
« Previous1…45678…31Next »
Ask Question