IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it What does a Frame Relay switch use to inform the sender that there is congestion?ITExamAnswers asked 9 months ago • CCNA Discovery v4At what physical location does the responsibilty for a WAN connection change from the user to the service provider?ITExamAnswers asked 2 years ago • CCNA 4 v4, CCNA Discovery v4Which three statements describe functions of the Point-to-Point Protocol with regards to the OSI model?(Choose three.)ITExamAnswers asked 9 months ago • CCNA Discovery v4What two services allow the router to dynamically map data link layer addresses to network layer addresses Frame Relay network? (Choose two.)ITExamAnswers asked 9 months ago • CCNA Discovery v4What best describes the use of a data-link connection identifier (DLCI)?ITExamAnswers asked 2 years ago • CCNA 4 v4, CCNA Discovery v4Which three statements are true regarding LCP? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 4 v4, CCNA Discovery v4Refer to the exhibit. What statement is true about the exhibited output?ITExamAnswers asked 9 months ago • CCNA Discovery v4Refer to the exhibit. A network administrator has a connectivity problem between the serial interfaces of Merida and Vargas. What is the cause of the problem?ITExamAnswers asked 9 months ago • CCNA Discovery v4Which statement is true about the Cisco implementation of the HDLC protocol?ITExamAnswers asked 9 months ago • CCNA Discovery v4In which two layers of the OSI model are key differences found between a LAN and a WAN. (Choose two.)ITExamAnswers asked 9 months ago • CCNA Discovery v4What is the data transmission rate for the DS0 standard?ITExamAnswers asked 9 months ago • CCNA Discovery v4Refer to the exhibit. RTRC was recently configured and is not sending the proper OSPF routes to RTRB, as shown in the RTRB routing table. Based on the RTRC configuration, what is most likely the problem?ITExamAnswers asked 9 months ago • CCNA Discovery v4If a network has converged, what is true about the link-state database held by each router in the same OSPF area?ITExamAnswers asked 9 months ago • CCNA Discovery v4What are some of the advantages of using a link-state routing protocol instead of a distance vector routing protocol? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4, CCNA Discovery v4When compared to a distance vector routing protocol, what is a benefit of the hierarchical design approach that is used in large OSPF networks?ITExamAnswers asked 9 months ago • CCNA Discovery v4