IT Questions Bank

IT Questions Bank 1

Which Catalyst feature causes a switch port to enter the spanning-tree forwarding state immediately?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
Refer to the exhibit. The switches are interconnected by trunked links and are configured for VTP as shown. A new VLAN is added to Switch1. Which three actions will occur? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
Using STP, how long does it take for a switch port to go from the blocking state to the forwarding state?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
Which statement best describes adaptive cut-through switching?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
What is the purpose of VTP?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
In which STP state does a switch port transmit user data and learn MAC addresses?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
What is the first step in the process of convergence in a spanning tree topology?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
Which two characteristics describe a port in the STP blocking state? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
Which two items will prevent broadcasts from being sent throughout the network? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
Which three steps should be taken before moving a Catalyst switch to a new VTP management domain? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
Refer to the exhibit. The switches in the exhibit are connected with trunks within the same VTP management domain. Each switch is labeled with its VTP mode. A new VLAN is added to Switch3. This VLAN does not show up on the other switches. What is the reason for this?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
Which three must be used when a router interface is configured for VLAN trunking? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
Refer to the exhibit. Switch1 is not participating in the VTP management process with the other switches. Which two are possible reasons for this? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
When are MAC addresses removed from the CAM table?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
A router has two serial interfaces and two Fast Ethernet interfaces. This router must be connected to a WAN link and to a switch that supports four VLANs. How can this be accomplished in the most efficient and cost-effective manner to support inter-VLAN routing between the four VLANs?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
« Previous1…7475767778…1,316Next »
Ask Question