While configuring inter-VLAN routing on a multilayer switch, a network administrator issues the no switchport command on an interface that is connected to another switch. What is the purpose of this command?

IT Questions BankCategory: CCNAWhile configuring inter-VLAN routing on a multilayer switch, a network administrator issues the no switchport command on an interface that is connected to another switch. What is the purpose of this command?

Question:
While configuring inter-VLAN routing on a multilayer switch, a network administrator issues the no switchport command on an interface that is connected to another switch. What is the purpose of this command?

  • to create a routed port for a single network
  • to provide a static trunk link
  • to create a switched virtual interface
  • to provide an access link that tags VLAN traffic

Explanation: When a Layer 2 interface on a multilayer switch is configured with the no switchport command, it becomes a routed port. A routed port is configured with an IP address for a specific subnet.

Exam with this question: CCNA 3 (v5.0.3 + v6.0) Chapter 2 Exam Answers
Exam with this question: CCNA 2 (v5.0.3 + v6.0) Chapter 5 Exam Answers
Exam with this question: 4.5.4 Module Quiz - Inter-VLAN Routing Answers

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments