IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 3 v4Which type of traffic can still be received on a switch interface that is in STP blocking mode?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What can be determined from the configuration of this wireless device?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. If switch SW1 is configured with the four VLANs as shown in the exhibit, how many physical interfaces are needed on router R1 to configure inter-VLAN routing using subinterfaces?ITExamAnswers asked 2 years ago • CCNA 3 v4When port security is used on a switch, which violation mode will cause an SNMP trap to be sent and traffic to be dropped when the number of secure MAC addresses for a port is reached?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. An administrator documented the output of a CAM table from an Ethernet switch as shown. What action will the switch take when it receives the frame shown at the bottom of the exhibit?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. A new host needs to be connected to VLAN 1. Which IP address should be assigned to this new host?ITExamAnswers asked 2 years ago • CCNA 3 v4In which mode is a VTP switch operating if it does not allow for the creation of local VLANs but it does accept VLAN updates from other switches in the same domain?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. VTP pruning is enabled in the VTP domain that is shown. How will switch ST-1 handle Layer 2 broadcast traffic originating from host A on switch ST-C?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Which three options correctly identify information that could be associated with this output?(Choose three.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Hosts A and B, connected to hub HB1, attempt to transmit a frame at the same time but a collision occurs. Which hosts will receive the collision jamming signal?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. A network administrator has segmented the network into two VLANs and configured Router1 for inter-VLAN routing. A test of the network, however, shows that hosts on each VLAN can only access local resources and not resources on the other VLAN. What is the most likely cause of this problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. After entering the commands in the exhibit, the administrator receives a “password required, but none set” message when attempting to connect to S1. What is the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What is the result of issuing these commands?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What will be the result of the commands that are shown in the exhibit?ITExamAnswers asked 2 years ago • CCNA 3 v4What is the purpose of issuing the command switchport mode access on a switch interface?ITExamAnswers asked 2 years ago • CCNA 3 v4