IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA 3 v4
A network administrator issued the erase nvram: command on a switch. What will be the outcome of the command?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. A network administrator has segmented the network into two VLANs and configured R1 and S1 as displayed. However, PC1 is unable to access PC2. What is the likely problem?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What operational change will occur if an 802.11b client associates with an access point that is currently supporting clients utilizing 802.11g?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What does TKIP have in common with AES?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. What does “LEARNING” mean as it relates to the Spanning Tree Protocol?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What happens when the crypto key zeroize rsa command is entered on a switch configured with thetransport input ssh command on the vty lines?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. A network administrator is configuring RT1 for inter-VLAN routing. The switch is configured correctly and is functional. Host1, Host2, and Host3 cannot communicate with each other. Based on the router configuration, what is causing the problem?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
Why is priority configured in 4096 increments when using PVST+?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. The network administrator needs to remove the east-hosts VLAN and use the switch port from that VLAN in one of the existing VLANs. Which two sets of commands should be used when completely removing VLAN 2 from S1-Central while leaving the switch and all its interfaces operational? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
A network administrator enters the enable command at the Switch> prompt of a new switch. What mode will the switch enter?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What type of message do wireless clients transmit when they are searching for a specific wireless network?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. Which two settings show the default value of VTP configuration on a Cisco 2960 switch? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. The network consists of four hubs and a switch. The hosts connected to each hub are assigned addresses in the respective VLAN as shown. PC1 on VLAN 1 becomes infected with a virus and initiates a continuous IP broadcast. Which hubs will receive the broadcasts?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. Users A and B are reporting intermittent connectivity problems. Pre-installation surveys showed strong signal strength from the AP locations to the client locations. Outside electrical interference has been eliminated. What will fix the problem?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. A network administrator has segmented the network into two VLANs. The connected hosts can only access resources in their own VLAN. What is the most scalable and cost effective solution to allow inter-VLAN communication in this network?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
« Previous1…678910…24Next »
Ask Question