IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA 3 v4
What are two requirements for configuring inter-VLAN routing using the router-on-a-stick model? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. Hosts PC_A and PC_B send traffic simultaneously, and the frames from the transmitting stations collide. What is the last device to receive the collision?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. What will allow a host on VLAN 40 on switch X to communicate with a host in VLAN 40 on switch Y?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. A network administrator issues the show interfaces fastEthernet 0/8 switchport command to check the status of the port. What can be concluded from the output?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. A network administrator enters the displayed commands to configure VLAN 30. What is the result of running these commands?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which two operations can be performed from the boot loader command line of a Cisco Catalyst switch? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which statement correctly describes an IBSS?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. VLAN 20 was recently added on the network. Users on VLAN 20 on SW1 start complaining that they do not have connectivity to the users on the same VLAN on switch SW2. What should be done to remedy the problem?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. Router R1 is connected to a switch through a trunk. What two ways are indicative of how the router handles incoming VLAN traffic? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which type of VLAN would accommodate untagged traffic on a 802.1q trunk port?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
A network administrator is planning the upgrade of an enterprise LAN to feature Layer 3 support for the application of data security policies, aggregated links, and redundant devices and links. Which switches in the hierarchical three-layer design model support these network requirements?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
Refer to the exhibit. Switch SWA is not processing VTP advertisments from switch SWB. What can done to correct the error?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. Which two switch interfaces would be RSTP edge ports? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. Which statement is true about the status of interface Fa0/1?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What is the purpose of configuring a switch port as a trunk port?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
« Previous1…7891011…24Next »
Ask Question