IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 3 v4Which switch forwarding method should be used on a network that employs frame classification based on an assigned Quality of Service (QoS) value?ITExamAnswers asked 2 years ago • CCNA 3 v4Which service should be disabled on a Cisco switch or router to prevent packet sniffers from capturing information about the device?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The commands are entered into switch SW1 as shown, and an 802.1q trunk is successfully established. How does switch SW1 handle the untagged traffic that is destined for the trunk?ITExamAnswers asked 2 years ago • CCNA 3 v4What advantage does cut-through switching provide?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. A new switch, SW3, has been added to the network. The network administrator determines that VLAN information is not propagating to SW3. Which command will remedy the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What does the term DYNAMIC indicate in the output that is shown?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. A network administrator needs to add IP phones to the network. To which devices should the IP phones connect?ITExamAnswers asked 2 years ago • CCNA 3 v4Which combination of DTP modes set on adjacent switches will cause the link to become an access link instead of a trunk link?ITExamAnswers asked 2 years ago • CCNA 3 v4What is an efficient and cost effective way to minimize the frequency and effects of broadcast storms on an Ethernet LAN?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. All hosts are in listen mode. Host 1 and Host 4 both transmit data at the same time. How do the hosts respond on the network? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4What are two benefits of the IEEE 802.11n standard over the IEEE 802.11G? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Which three statements are true regarding router-on-a-stick inter-VLAN routing? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The devices in the network are operational and configured as indicated in the exhibit. However, hosts B and D cannot ping each other. What is the most likely cause of this problem?ITExamAnswers asked 2 years ago • CCNA 3 v4What identifier in the BPDU creates a unique BID for a switch?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The network administrator wants to allow both SSH and Telnet connections to Switch1. However, the SSH connections fail. What is the most likely cause of this problem?ITExamAnswers asked 2 years ago • CCNA 3 v4