IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPRefer to the exhibit. A network engineer has issued the verification command while troubleshooting a routing loop on the network. What is the error in the configuration?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. A network administrator is troubleshooting a recent OSPF stub configuration between R3 and R4. The only routes that should appear on the routing table for R4 are intra-area routes and the default route. However, interarea routes are also appearing. What must the administrator do to fix this problem?IT Administrator asked 3 years ago • CCNPRefer to the exhibit. A network engineer has performed a partial configuration to prevent routes from being reinjected. What is the next configuration that should be issued?IT Administrator asked 3 years ago • CCNPWhich two statements are true of policy-based routing (PBR) as a path control tool? (Choose two.)IT Administrator asked 3 years ago • CCNP, CCNP ROUTEWhich two networks would match the following prefix list? (Choose two.)IT Administrator asked 3 years ago • CCNP, CCNP ROUTEWhat is a characteristic of an IBGP session type?ITExamAnswers asked 4 years ago • CCNP, CCNP ROUTEWhich two variables must match between two OSPF routers to form a neighbor adjacency? (Choose two.)IT Administrator asked 4 years ago • CCNP, CCNP ROUTEOn an OSPF multiaccess network, which multicast address must a non-DR router use to send an LSU packet that contains new link-state information?ITExamAnswers asked 3 years ago • CCNP, CCNP ROUTEAn administrator wants to configure EIGRPv6 in an IPv6 network. Which three statements are valid for the configuration of EIGRPv6? (Choose three.)IT Administrator asked 3 years ago • CCNPMultiple paths exist in the BGP table. Assuming the weights are the same, what will the next determining factor be?IT Administrator asked 3 years ago • CCNP, CCNP ROUTE, CCNPv8 ENARSIRefer to the exhibit. A two-way redistribution is configured on router R2 between the EIGRP and the OSPF domains. The show ip route command output taken on R3 reveals that the network 10.10.10.16/28 is not installed in the routing table. What could be the problem?ITExamAnswers asked 1 year ago • CCNP, CCNP ROUTEWhen would the network administrator use the ip bandwidth-percent eigrp as-number percent command?ITExamAnswers asked 3 years ago • CCNA 2 v4, CCNP, CCNP ROUTEHow does OSPF exchange routing updates when the passive-interface command is applied?ITExamAnswers asked 4 years ago • CCNP, CCNP ROUTEWhich BGP attribute can be configured on IBGP speakers so they will choose a desired path out of the autonomous system to an outside network?IT Administrator asked 4 years ago • CCNP, CCNP ROUTEHow does Cisco implement interarea OSPF summarization?IT Administrator asked 3 years ago • CCNP