IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPRefer to the exhibit. Which two conclusions can be derived from the output? (Choose two.)ITExamAnswers asked 4 years ago • CCNP, CCNAIf replies are not received from all outstanding queries, how long will an EIGRP router wait before placing a route into the SIA state?ITExamAnswers asked 3 years ago • CCNP, CCNP ROUTEWhen creating an IPv6 static route, when must a next-hop IPv6 address and an exit interface both be specified?ITExamAnswers asked 4 years ago • CCNA, CCNPWhich three requirements are necessary for two OSPFv2 routers to form an adjacency? (Choose three.)ITExamAnswers asked 4 years ago • CCNP, CCNAA network administrator is teaching a junior network engineer about EIGRP stub routers. Which two explanations can be given to the junior engineer about the subject? (Choose two.)IT Administrator asked 3 years ago • CCNPWhich is the correct order of the four steps to configure CoPP on a Cisco router?IT Administrator asked 3 years ago • CCNPA network administrator is configuring IPv6 route summarization on a BGP router with the command aggregate-address 2001:db8::/60 summary-only . Which two component networks match the aggregated route? (Choose two.)IT Administrator asked 3 years ago • CCNP, CCNPv8 ENARSIRefer to the exhibit. A network administrator issues the show bgp ipv4 unicast 10.1.1.128 command on router R2 to verify the network 10.1.1.128 in the BGP table. The administrator notices that there are two paths to reach the network and the path through the neighbor 1.1.1.1 is the best-path. Which configuration step will allow the administrator to change the best path to use neighbor 3.3.3.3?IT Administrator asked 3 years ago • CCNPWhich two statements describe the BGP weight attribute? (Choose two.)IT Administrator asked 3 years ago • CCNPRefer to the exhibit. A network administrator is configuring the syslog service on a Cisco router. Which command should be used to configure an IPv4 address of 192.168.10.254 as the source address on the syslog packets as they exit the router R1?IT Administrator asked 3 years ago • CCNPRefer to the exhibit. A network administrator has configured two-way redistribution on router R1. What metrics will be used for redistributed routes?IT Administrator asked 3 years ago • CCNPIn order to limit spoofed packets on a network, a network administrator is configuring uRPF on a Cisco router interface with the ip verify unicast source reachable-via rx command. After the configuration is completed, the administrator observes that valid packets are being dropped. What may be causing this packet discard?IT Administrator asked 3 years ago • CCNP, CCNPv8 ENARSIRefer to the exhibit. Why did R1 and R2 not establish an adjacency?ITExamAnswers asked 4 years ago • CCNA, CCNP, CCNPv8 ENARSIWhich capability is supported by all three DMVPN phase models?ITExamAnswers asked 3 years ago • CCNP, CCNPv8 ENARSIWhat is the reason for a network engineer to alter the default reference bandwidth parameter when configuring OSPF?ITExamAnswers asked 4 years ago • CCNA, CCNP, CCNPv8 ENARSI