IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPA network administrator is configuring an ACL to match networks for BGP route filtering. The administrator creates an ACE permit ip 10.0.128.0 0.0.63.0 255.255.255.0 0.0.0.0. Which network matches the ACE?ITExamAnswers asked 4 years ago • CCNPA network administrator is configuring a prefix list to match networks for BGP route filtering. Which two networks match the prefix match specification 10.224.0.0/12 ge 24 le 28 ? (Choose two.)IT Administrator asked 4 years ago • CCNPWhat is the correct BGP command to summarize the addresses from 172.16.0.0 through 172.16.15.0 into a single address that will be advertised by BGP?ITExamAnswers asked 4 years ago • CCNPRefer to the exhibit. A network administrator is troubleshooting BGP configuration and wants to verify routes that carry the 100 AS in the AS_Path value. Which regular expression should the administrator use in the command show bgp ipv4 unicast regex regex-pattern?ITExamAnswers asked 4 years ago • CCNPWhich two statements describe the configuration differences when MP-BGP is applied using the IPv6 protocol compared to IPv4 protocol? (Choose two.)IT Administrator asked 4 years ago • CCNPWhat change was made to BGP to address the expected depletion of autonomous system numbers?ITExamAnswers asked 4 years ago • CCNPRefer to the exhibit. A network administrator issues the show bgp ipv4 unicast begin Network command to check the routes in the BGP table. What does the symbol ? at the end of a route indicate?IT Administrator asked 3 years ago • CCNPWhich method is used to provide a loop-free routing BGP table for IBGP routers in a single AS?ITExamAnswers asked 3 years ago • CCNPA network administrator issues the show bgp ipv4 unicast summary command to verify the BGP session after basic BGP configuration is completed. Which three pieces of information are found in the BGP session summary? (Choose three.)IT Administrator asked 3 years ago • CCNPWhat is the first BGP message type that is sent after a TCP session is established between BGP peers?ITExamAnswers asked 4 years ago • CCNPWhat is used by BGP to determine the best path to a destination?ITExamAnswers asked 4 years ago • CCNA, CCNPWhich two characteristics are associated with IBGP? (Choose two.)ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. A network administrator is configuring BGP on the router RT1. Which command set will allow RT1 to establish a neighbor relationship with RT2?IT Administrator asked 3 years ago • CCNPWhich routing protocol is used to exchange routing information between autonomous systems on the Internet?ITExamAnswers asked 4 years ago • CCNPWhich transport layer port is used in BGP peering?ITExamAnswers asked 4 years ago • CCNP