IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPRefer to the exhibit. An administrator applies the configurations to routers R1 and R2 respectively. Both routers use the FastEthernet0/0 interface to connect to the same Ethernet switch. However, a neighbor adjacency fails to form. What is a possible cause for the problem?ITExamAnswers asked 3 years ago • CCNPWhich OSPF LSA type provides information about IPv6 address prefixes associated with a transit network by referencing a network LSA?ITExamAnswers asked 3 years ago • CCNPWhich command can be used by an administrator to display a list of interfaces that are enabled for OSPFv3?ITExamAnswers asked 4 years ago • CCNA, CCNPAfter implementing an IPv6 network, the administrator notices that the OSPFv3 process is not starting on the routers. What could be the problem?ITExamAnswers asked 4 years ago • CCNA, CCNPA network administrator has enabled single-area OSPFv3 on a router via the ipv6 router ospf 100 command. Which command will enable this OSPFv3 process on an interface of that router?ITExamAnswers asked 3 years ago • CCNPWhich command will verify that a router running OSPFv3 has received a redistributed default static route from another OSPFv3 router?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. What type of OSPF router is HQ-3?ITExamAnswers asked 3 years ago • CCNPAn administrator is troubleshooting an OSPFv3 network and wants to view the PID, the RID, the reference bandwidth, and the area parameters for both IPv4 and IPv6 address families. Which single command can be used to display the information?ITExamAnswers asked 3 years ago • CCNPAn administrator is troubleshooting OSPFv3 adjacency issues. Which command would the administrator use to confirm that OSPFv3 hello and dead intervals are matching between routers?ITExamAnswers asked 3 years ago • CCNPA network engineer is troubleshooting a single-area OSPFv3 implementation across routers R1, R2, and R3. During the verification of the implementation, it is noted that the routing tables on R1 and R2 do not include the entry for a remote LAN on R3. Examination of R3 shows the following:ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. Which would be chosen as the router ID of R2?ITExamAnswers asked 4 years ago • CCNA, CCNPWhat is the IPv6 address used by OSPFv3 non-DR/BDR routers to send link-state updates and link-state acknowledgments?ITExamAnswers asked 4 years ago • CCNPWhat IPv6 address does an OSPFv3 router use as the source address for OSPFv3 packets exchanged with OSPFv3 neighbors?ITExamAnswers asked 4 years ago • CCNPWhich command should a network technician issue on a Cisco router to display status information about OSPFv3 IPv6 address family neighbor routers?ITExamAnswers asked 3 years ago • CCNPWhich LSA type is generated by all OSPFv3 routers to describe the state and cost of interfaces in an area?ITExamAnswers asked 4 years ago • CCNP