IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: Network Addressing and Basic TroubleshootingRefer to the exhibit. The IP address of which device interface should be used as the default gateway setting of host H1?ITExamAnswers asked 4 years ago • CCNA, CCNA CyberOps, IT Essentials 8, Network Addressing and Basic Troubleshooting, Networking Basics, Networking EssentialsA computer can access devices on the same network but cannot access devices on other networks. What is the probable cause of this problem?ITExamAnswers asked 4 years ago • CCNA, CCNA CyberOps, IT Essentials 8, Network Addressing and Basic Troubleshooting, Networking EssentialsWhich address is used to derive an IPv6 interface ID using the EUI-64 method?ITExamAnswers asked 1 year ago • Network Addressing and Basic TroubleshootingFollowing default settings, what is the next step in the router boot sequence after the IOS loads from flash?ITExamAnswers asked 4 years ago • Network Addressing and Basic TroubleshootingA network technician enters the command ipconfig /release followed by ipconfig /renew in order to ensure that the DHCP IP configuration on a workstation is updated. However, the workstation does not receive a valid IP configuration for the network. Which two problems may exist on the network? (Choose two.)ITExamAnswers asked 2 years ago • Network Addressing and Basic Troubleshooting, Networking EssentialsWhich statement describes the half-duplex mode of data transmission?ITExamAnswers asked 4 years ago • Network Addressing and Basic TroubleshootingWhich type of static route creates a gateway of last resort?ITExamAnswers asked 2 years ago • CCNA, Network Addressing and Basic TroubleshootingWhat type of route is indicated by the code C in an IPv4 routing table on a Cisco router?ITExamAnswers asked 4 years ago • Network Addressing and Basic Troubleshooting, Networking Basics, Networking EssentialsWhich media access method requires that an end device send a notification across the media before sending data?ITExamAnswers asked 4 years ago • CCNA, Network Addressing and Basic TroubleshootingWhich two statements correctly describe the components of a router? (Choose two.)ITExamAnswers asked 3 years ago • CCNA 2 v4, CCNA 2 v5, Network Addressing and Basic Troubleshooting, Networking EssentialsWhich two types of signal interference are reduced more by STP than by UTP? (Choose two.)ITExamAnswers asked 4 years ago • IT Essentials, IT Essentials 8, Network Addressing and Basic TroubleshootingAn IPv6 enabled device sends a data packet with the destination address of FF02::1. What is the target of this packet?ITExamAnswers asked 4 years ago • CCNP, Network Addressing and Basic TroubleshootingRefer to the exhibit. The command output is from a wireless DHCP host connected to a Linksys integrated router. What can be determined from the output?ITExamAnswers asked 2 years ago • Network Addressing and Basic Troubleshooting, Networking EssentialsA technician is setting up a network in a new room. What is the best device to use to connect the PCs to each other and to the rest of the LAN?ITExamAnswers asked 4 years ago • IT Essentials, Network Addressing and Basic Troubleshooting, Networking EssentialsUsers in a recently installed wireless network are complaining of slow data transfer and frequent loss of connectivity. The technician checks that the wireless security is correctly implemented, and there is no evidence of unauthorized users on the network. Which two problems might the technician suspect? (Choose two.)ITExamAnswers asked 4 years ago • IT Essentials, IT Essentials 8, Network Addressing and Basic Troubleshooting