Category: CCNA Discovery v4
1. It is important to identify the details of network sections and devices that will be affected or involved in a new design. This information is included in which section of the Network Design Requirements Document? Project Goal Project Scope Technical Requirements Current State of the Network 2. …
1. During an evaluation of the currently installed network, the IT staff performs a gap analysis to determine whether the existing network infrastructure can support the desired new features. At which stage of the Cisco Lifecycle Services approach does this activity occur? Prepare Phase Plan Phase Design Phase …
1. What are two mechanisms that provide redundancy for server farm implementations? (Choose two.) host intrusion prevention systems virtual private networks network intrusion prevention systems Rapid Spanning Tree Protocol Hot Standby Routing Protocol 2. The ability to connect securely to a private network over a public network is …
1. In which VTP mode can a switch create VLANs, ignore VTP messages, and not pass local VLAN information to other VTP domain members? client server pruning transparent 2. What are two characteristics of an extended ACL? (Choose two.) IP is used to specify TCP traffic only. IP …
1. Refer to the exhibit. Based on the output shown, to which IP network should the workstations in the Support department belong? 192.168.1.0 172.16.1.0 172.16.3.0 172.16.5.0 2. Refer to the exhibit. A network administrator is doing proactive network maintenance. The administrator pings 192.168.1.100 and compares the results to …
1. Refer to the exhibit. A network administrator needs to add the command deny ip 10.0.0.0 0.255.255.255 any log to R3. After adding the command, the administrator verifies the change using the show access-list command. What sequence number does the new entry have? 0 10, and all other …
1. Why are Network Control Protocols used in PPP? to establish and terminate data links to provide authentication capabilities to PPP to manage network congestion and to allow quality testing of the link to allow multiple Layer 3 protocols to operate over the same physical link 2. What …
1. Refer to the exhibit. What statement describes the DR/BDR relationship of the HQ router? HQ is the DR. HQ is the BDR. HQ is a DROTHER. HQ is a member of an NBMA network. 2. Which two features are associated with Frame Relay OSPF point-to-multipoint environments? (Choose …
1. What three statements are true about routers that are configured for EIGRP? (Choose three.) They can support multiple routed protocols They can support only link-state protocols. They send their entire routing tables to neighboring routers. They send partial routing updates in response to topology changes. They send …
1. A network engineer is implementing a network design using VLSM for network 192.168.1.0/24. After subnetting the network, the engineer has decided to take one of the subnets, 192.168.1.16/28 and subnet it further to provide for point-to-point serial link addresses. What is the maximum number of subnets that …
