IT Exam Items Repository

A switch is configured to run STP. What term describes a field that has a default value of 32,768 and is the initial deciding factor when electing a root bridge?
ITExamAnswers Editorial Team asked 7 years ago
A switch is configured to run STP. What term describes a field used to specify a VLAN ID?
ITExamAnswers Editorial Team asked 7 years ago
A switch is configured to run STP. What term describes a non-root port that is permitted to forward traffic on the network?
ITExamAnswers Editorial Team asked 7 years ago
What type of VLAN supports untagged traffic?
ITExamAnswers Editorial Team asked 7 years ago
What type of VLAN is designed to have a delay of less than 150 ms across the network?
ITExamAnswers Editorial Team asked 7 years ago
What type of VLAN is designed to reserve bandwidth to ensure IP Phone quality?
ITExamAnswers Editorial Team asked 7 years ago
What type of VLAN should not carry voice and network management traffic?
ITExamAnswers Editorial Team asked 7 years ago
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw> enable command?
ITExamAnswers Editorial Team asked 7 years ago
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw(config-if)# ipv6 address 2001:db8:a2b4:88::1/64 command?
ITExamAnswers Editorial Team asked 7 years ago
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw(config-if)# shutdown command?
ITExamAnswers Editorial Team asked 7 years ago
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw# configure terminal command?
ITExamAnswers Editorial Team asked 7 years ago
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw(config-if)# mdix auto command?
ITExamAnswers Editorial Team asked 7 years ago • 
A network technician is troubleshooting an issue and needs to verify all of the IPv6 interface addresses on a router. What is the best command to use to accomplish the task?
ITExamAnswers Editorial Team asked 7 years ago • 
A student wants to save a router configuration to NVRAM. What is the best command to use to accomplish the task?
ITExamAnswers Editorial Team asked 7 years ago • 
Students who are connected to the same switch are having slower than normal response times. The administrator suspects a duplex setting issue. What is the best command to use to accomplish the task?
ITExamAnswers Editorial Team asked 7 years ago • 
« Previous1…1,3581,3591,3601,3611,362…1,378Next »