IT Exam Items Repository

Refer to the exhibit. A network designer is testing a prototype of WAN connection. All of the routers in the exhibit are configured for OSPF routing. The design requires that the path between routers A and D through ISP-A is the primary and the path through ISP-B serves as a backup. The designer notice that router A has two equal-cost paths to the LAN on router D. How can the designer correct this problem?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. Two routers are unable to establish an adjacency. What is possible cause for this?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. The network administrator is planning IP addressing of a new network. What part of this addressing scheme must be changed to allow communication between hostA and the server?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. What summarization should R2 use to advertise its LAN networks to R1?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to exhibit. All routers are advertised and fully operational on all routers. Which statement is true about the path that the data will take from router A to router B?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to exhibit. The network is using the RIPv2 routing protocol. If network 10.0.0.0 goes down, what mechanism will prevent Router1 from advertisting false routing information back to Router2?
ITExamAnswers Editorial Team asked 4 years ago • 
Router R1 is participating in the OSPF routing protocol as well as the EIGRP routing protocol. If R1 learns of network 192.168.10.0/24 from both the OSPF and internal EIGRP routing protocols, how will the route appear in the routing table of R1?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. What is the cost of the route to the 172.16.2.128 network with the subnet mask of 255.255.255.128?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. What OSPF packets will trigger the reset of the Dead Time counter?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. Routers R1, R2, and R3 have four local LANs attached. What is a correct set of network commands that will cause OSPF to be enabled for any R1 interface that is connected to its subnets?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. What does the “2″ stand for in the router ospf 2 statement?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. Which network command or set of commands will cause OSPF to be enabled for any R1 interface connected to the exhibited subnets?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. What does the “O*E2″ from the “O*E2 0.0.0.0/0 [110/1] via 192.168.1.1, 00:05:34, Serial0/0″ line represent?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. What must be received between neighbors to prevent the dead time that is shown in the exhibit from reaching zero?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. The network administrator wants to set the router ID of Router1 to 192.168.100.1. What steps can the administrator take to accomplish this?
ITExamAnswers Editorial Team asked 4 years ago • 
« Previous1…749750751752753…1,378Next »
Ask Question